RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 135 views POST REPLY
HelicopterFlybarless Rotor Head SystemsBeastX › BeastX V5 strange one
03-16-2018 04:04 PM  39 days agoPost 1
tgalo

rrApprentice

USA

My Posts: All  Forum  Topic

Thought Id throw this out there. BeastX HD flashed to V5. Using it on a four servo,90 degree swash. When I set the mixing type, should be a "red flashing". Every time I power the unit down and back up it defaults to "custom" or LED off. Have to go back in the setup and change the swash type to 90 degree and works fine again till I power it down. Any ideas? Thanks

Gravity's a bitch ant it?

PM  EMAIL  GALLERY  Attn:RR  Quote
03-16-2018 05:19 PM  38 days agoPost 2
Pistol Pete

rrProfessor

Seffner, FL

My Posts: All  Forum  Topic

I would just reset the unit to default and start over.

If it happens again, then it definitely is a software glitch.

~~Enjoying the hobby one flight at a time~~

PM  EMAIL  HOMEPAGE  GALLERY  BLOGAttn:RR  Quote
03-16-2018 05:29 PM  38 days agoPost 3
tgalo

rrApprentice

USA

My Posts: All  Forum  Topic

Yeah, I did re-flash it. Same thing. I emailed the BeastX folks. See what they say. Definitly strange,thanks

Gravity's a bitch ant it?

PM  EMAIL  GALLERY  Attn:RR  Quote
03-23-2018 09:40 PM  31 days agoPost 4
tgalo

rrApprentice

USA

My Posts: All  Forum  Topic

Well Pete you were right. It turned out to be in their firmware. They had the same glitch on their test. So he told me to try the StudioX app. I did and it worked. Hopefully this post will help someone

Gravity's a bitch ant it?

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 135 views POST REPLY
HelicopterFlybarless Rotor Head SystemsBeastX › BeastX V5 strange one
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Tuesday, April 24 - 5:01 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online