RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 161 views POST REPLY
HelicopterFlybarless Rotor Head SystemsBeastX › Internal Gov Setup
12-01-2017 08:05 PM  82 days agoPost 1
Gringle

rrNovice

queen creek az

My Posts: All  Forum  Topic

howdy all....

I finally got my rpm sensor installed with my beastx plus and for the first time today flew it..... but not with the results I think I want..

Equipment:
Gaui NX4 with T-10 gas engine
Align rpm sensor on magnets and the beastx connection to the FBL unit

I went thru the setup and confirmed the beastx plus was sensing the magnets. Everything seemed to go well with the setup. I set it up with the two channel option so I could engage the gov after I spooled up and established hover.

Flight test was as follows.
I lifted off and established my hover at a little over mid stick. Switched into idle up 1 which a v curve that is about the same throttle percentage as my hover speed (maybe a little more).
From here is engaged the governor and the motor for lack of a better word seemed to drop really fast then pick back up. Almost like the throttle dropped fast then pick back up. But I think it comes back onto the throttle curve and not governed. Almost like the gov kicks out. Hmmmm.. maybe back to drawing board

PM  EMAIL  GALLERY  Attn:RR  Quote
12-02-2017 07:40 AM  82 days agoPost 2
Pistol Pete

rrProfessor

Seffner, FL

My Posts: All  Forum  Topic

Flight test was as follows.
I lifted off and established my hover at a little over mid stick. Switched into idle up 1 which a v curve that is about the same throttle percentage as my hover speed (maybe a little more).
...

Some transmitters offer a special setting that allows to automatically switch the auxiliary governor channel together with the flight mode switch. So the motor can be ignited in the first flight mode and you can spool up the rotor and hover the heli by applying throttle manually. With the second flight mode the throttle curve is a "V"-shaped curve and simultaneously the RPM Governor is turned on by the auxiliary channel. In this case pay special attention that the two throttle curves/throttle positions match as good as possible in the stick point at which you usally switch flight modes. Otherwise the throttle servo would make a jump before the RPM Governor will take over control as you still may be in manual mode for a short amount of time. So in this type of operation it is not possible to activate the RPM governor from idle position and let the rotor spool up autonomously. If you want this, you must activate the RPM Governor before switching to your second flight mode with an additional switch!

Cut and paste from
http://wiki.beastx.com/index.php/Ma...vernor_usage/en

~~Enjoying the hobby one flight at a time~~

PM  EMAIL  HOMEPAGE  GALLERY  BLOGAttn:RR  Quote
WATCH
 1 page 161 views POST REPLY
HelicopterFlybarless Rotor Head SystemsBeastX › Internal Gov Setup
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Thursday, February 22 - 7:05 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online