RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 105 views POST REPLY
Hitec RCD ProModeler
HelicopterTurbine Helicopters › Vbar Neo and Jetcat Pht-3
05-13-2017 03:23 PM  12 days agoPost 1
KevinChiu123

Senior Heliman

Taipei, Taiwan

My Posts: All  Forum  Topic

Hi, can anyone teach me how to calibrate Jetcat pht-3's throttle setting (throttle trim~ low for shutdown, high for ignition) and throttle stick (high-low transition) with Vbar Neo as the RX?

My TX is JR 12X

Thanks a lot for your helps.

Best wishes,

PM  EMAIL  GALLERY  Attn:RR
05-14-2017 03:51 AM  12 days agoPost 2
Dan Minick

Key Veteran

Columbus, WI

My Posts: All  Forum  Topic

Should be the same process as the last Vbar's as long as you are not using a Vbar control.

Setup Bank 1 in the software to have direct throttle control then program your ECU. You can leave as is or switch Bank 1 back to a governed mode.

Team Synergy, Team FBL Rotors---Formerly Dyecocker1-------if its not broke...it will be!

PM  EMAIL  GALLERY  Attn:RR
05-14-2017 04:31 PM  11 days agoPost 3
KevinChiu123

Senior Heliman

Taipei, Taiwan

My Posts: All  Forum  Topic

Thanks a lot for your reply.

I believe that I find out the answer.

JR 12X's throttle trim is analog type.

Vbar Neo does not support this type.

I will put on a Futaba system.

PM  EMAIL  GALLERY  Attn:RR
05-14-2017 05:49 PM  11 days agoPost 4
Dan Minick

Key Veteran

Columbus, WI

My Posts: All  Forum  Topic

That is unfortunate. I was not aware, thanks for the heads up!

Team Synergy, Team FBL Rotors---Formerly Dyecocker1-------if its not broke...it will be!

PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 105 views POST REPLY
Scorpion Power GLOBAL 3D
HelicopterTurbine Helicopters › Vbar Neo and Jetcat Pht-3
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Friday, May 26 - 10:20 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online