RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 252 views POST REPLY
Scorpion Power GLOBAL 3D
05-11-2017 02:18 PM  44 days agoPost 1
shiver

Senior Heliman

Ireland

My Posts: All  Forum  Topic

Is anyone using align ds450 with a mini v bar. I am having compatibilty issues. Savox sh0257 and align ds430 both not initializing properly.

PM  EMAIL  GALLERY  Attn:RR
05-11-2017 03:45 PM  44 days agoPost 2
Tyler

Elite Veteran

Chicagoland area

My Posts: All  Forum  Topic

Check your esc voltage output during boot up. If not high enough voltage is detected, the gyro wont initialize. The esc may then also be holding back bec voltage output because they vbar mini didnt initialize. This can sometimes be an endless loop. One device awaiting confirmation from the other device.

A simple way to test in two ways.

1. Measure the bec voltage going into the gyro when battery is plugged in.

2. Add a rx battery. Initialize the gyro with the rx battery. Wait for the swash plate twitch to verified it is ready. Then plug in the flight pack.

Enjoy things that money can buy IF you don't lose the things money can't buy.

PM  EMAIL  GALLERY  Attn:RR
05-11-2017 04:13 PM  44 days agoPost 3
shiver

Senior Heliman

Ireland

My Posts: All  Forum  Topic

Thanks a ton.

PM  EMAIL  GALLERY  Attn:RR
05-11-2017 05:17 PM  44 days agoPost 4
Heli Fanatix

Veteran

Fountain Valley, CA

My Posts: All  Forum  Topic

Alternatively you can just initialize the setup with only 1 Servo plugged in.
- if everything boot up fine
- the servos are drawing too much current at once and not letting the mini v initialize and doing what Tyler has described
- BEC inadequate (which is pretty surprising since most BEC are robust now-a-days)

- Scott

PM  EMAIL  GALLERY  Attn:RR
05-13-2017 07:32 AM  42 days agoPost 5
shiver

Senior Heliman

Ireland

My Posts: All  Forum  Topic

I just tried align DS450 servos and all is good. It must be servo related and only with certain servos. Thanks for the help much appreciated.

PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 252 views POST REPLY
ProModeler Scorpion Power
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Sunday, June 25 - 1:16 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online