RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 369 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Blade
Blade 300 › Can I go directly to step J on the Beast controller?
04-13-2017 10:36 PM  6 months agoPost 1
totally_awesome

rrApprentice

Fredericksburg, Virginia

My Posts: All  Forum  Topic

Hello,

Can I go directly to step J (Teaching Cyclic Pitch Geometry) on the Beast controller? All if want/need to do is to adjust the pitch.

Regards, Dave

PM  EMAIL  Attn:RR  Quote
04-13-2017 10:39 PM  6 months agoPost 2
Heli Fanatix

rrVeteran

Fountain Valley, CA

My Posts: All  Forum  Topic

yes you can!

FYI
Just don't stop at G
- if you do, make sure you are on a color
- otherwise swash plate will not be leveled

- Scott

PM  EMAIL  GALLERY  Attn:RR  Quote
04-16-2017 04:37 PM  6 months agoPost 3
totally_awesome

rrApprentice

Fredericksburg, Virginia

My Posts: All  Forum  Topic

Hello,

Thanks for getting back to me. I just wanted to know if I can do one (or more) of the setup steps, if needed, look like I can. I want want to see if I have to do them all, if I only wanted to adjust one parameter.
I have borrowed a swash leveling tool and have adjusted my swash plate to be level by making the needed mechanical adjustments, (no subtrims, etc required).

Regards, Dave

PM  EMAIL  Attn:RR  Quote
04-16-2017 10:05 PM  6 months agoPost 4
Heli Fanatix

rrVeteran

Fountain Valley, CA

My Posts: All  Forum  Topic

Let me give you some examples:
Let say you adjusted Parameter A & D
- press the button to cycle through them all

Let say you are on Parameter G
- first time you are leveling it
- you have to do all 3 cyclics
- than the adjustments are stored in Beastx
- if you go into just one cyclic under Parameter G, you can press the button as long as a LED lighted up

FYI
You have to make sure the
- Servo to Swashplate links are same length
- Servo are centered
- if Servo to swashplate links are not the same, the travel will be different
- adjust links according to Align Trex 500 ESP FBL specs

- Scott

PM  EMAIL  GALLERY  Attn:RR  Quote
04-18-2017 02:15 PM  6 months agoPost 5
pH7

rrKey Veteran

Sterling Heights, MI - USA

My Posts: All  Forum  Topic

The steps for a new setup should be followed in order. There are some later steps that are dependent on the settings of an earlier step. After a setup is complete, you can skip right to any step, but a setting you change may effect some later step. If you understand the dependencies and are sure, you can just step through to the end to save the new setting. If you don't, then at least check the later steps to make sure the change you made didn't effect them.

Phil Heavin

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 369 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Blade
Blade 300 › Can I go directly to step J on the Beast controller?
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Tuesday, October 17 - 2:31 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online