RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 239 views POST REPLY
ProModeler Scorpion Power
Helicopter
e-
Align
T-REX 700 › Should we change to the H70G008AXW CNC Slant Thread Main Drive Gear/110T on the MX850 Motors?
04-02-2017 08:19 PM  4 months agoPost 1
NQNA

Elite Veteran

USA

My Posts: All  Forum  Topic

This might have been covered before, but I have a question on the upgrade to the H70G008AXW wide main gear when using the Align MX850 430KV motor. Has there been a widespread problem with the narrow gear failing under load? I'm converting my 700E DFC Pro to the MX850 so any personal history with this issue would be appreciated!

PM  EMAIL  GALLERY  Attn:RR
04-03-2017 02:35 AM  4 months agoPost 2
knightofcarnage

Elite Veteran

chicago

My Posts: All  Forum  Topic

Best of my knowledge the gears came out because of the 3 blades setup to help with the extra blade load, not because of gear failing. I have both 850 MX 490Kv and 540Kv and used old gears with out issues. Only thing that I'm aware of fail was rear TT gears. But best to my knowledge it was caused by tail boom assembly flexing under high load changes. But this was only on the 700X not the older models.

PM  EMAIL  GALLERY  Attn:RR
04-03-2017 03:18 AM  4 months agoPost 3
NQNA

Elite Veteran

USA

My Posts: All  Forum  Topic

Thx Knight. I have the older 110t and 13t gear setup that I will use. I already have the new reds for the tail gear sets that I'm going to install even though mine is the DFC Pro version.

PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 239 views POST REPLY
ProModeler Scorpion Power
Helicopter
e-
Align
T-REX 700 › Should we change to the H70G008AXW CNC Slant Thread Main Drive Gear/110T on the MX850 Motors?
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Friday, August 18 - 7:55 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online