RunRyder RC
 2  Topic Subscribe
WATCH  1 page 247 views POST REPLY
Hitec RCD ProModeler
Helicopter
e-
Mikado Logo 400 500 600 700 800
Logo 550 › Kontronik jive lv 100 r.p.m. setup in neo?
chicken

Heliman

naugatuck, ct,usa

My Posts: All  Forum  Topic

Is there anyway to set headspeed in neo using kontronik jive 100 or is it just set via the flight mode. Normal, idle up 1, idle up 2 etc. And what's the purpose of the bank switch 1,2,3 ? As when I click on either of the 3 all I get is a "copy"??? As the only way to get the motor to start is to set my throttle points at 70% ex. Normal 0,70,70. Idle 1 80,80,80

12-31-2016 03:04 AM
PM  EMAIL  Attn:RR
Tyler

Elite Veteran

Chicagoland area

My Posts: All  Forum  Topic

Are you using Vcontrol radio? If so, you have to use the Kontronik governor. Go into the model set up/esc wizard/kontronik/ then select which esc you have.

You will then be able to set the esc output for each flight mode.

If you have an rpm sensor you can view the rpm on the tx screen and also have the voice announce the rpm to you while flying. Simply adjust the esc output values until you get the desired head speed for each flight mode.

Enjoy things that money can buy IF you don't lose the things money can't buy.

12-31-2016 04:59 AM
PM  EMAIL  GALLERY  Attn:RR
chicken

Heliman

naugatuck, ct,usa

My Posts: All  Forum  Topic

No I'm using a jr 11x transmitter & I don't have an rpm sensor & the jr 11x governor setting is basically for the throttle adjust as I recall because I'm responding to your assistance while not near my computer but everything seems to work while testing at computer at home I'm just concerned because I've always been told that you should be able to adjust your head speed so as to not over speed & the manual recommends a max. Of 2000 rpm

12-31-2016 04:06 PM
PM  EMAIL  Attn:RR
WATCH  1 page 247 views POST REPLY
Scorpion Power Hitec RCD
Helicopter
e-
Mikado Logo 400 500 600 700 800
Logo 550 › Kontronik jive lv 100 r.p.m. setup in neo?
 Print TOPIC Advertisers 

 2  Topic Subscribe

Thursday, March 30 - 3:37 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies