RunRyder RC
 3  Topic Subscribe
WATCH
 1 page 486 views POST REPLY
Scorpion Power ProModeler
HelicopterGaui NX4 NX7Gaui NX4 › OK So did the OS55 install and now...
09-12-2016 10:17 PM  10 months agoPost 1
Hate_To_Crash

Senior Heliman

Near Lake Tahoe

My Posts: All  Forum  Topic

The engine is not straight with the starter shaft.. I have seen plenty of talk about it Seems there are 2 ways.. Shim the motor forward or slot the starter shaft bearing holes in the frame

Looking for someone who has had same issue and how you resolved it??

Oh I have the 20 tooth bell and the fancy upgraded red bearing coupler

PM  EMAIL  GALLERY  Attn:RR
09-13-2016 04:29 PM  10 months agoPost 2
UK Helinut

Senior Heliman

Gloucestershire

My Posts: All  Forum  Topic

There is your problem, needs the standard gearing to line up.

PM  EMAIL  GALLERY  Attn:RR
02-06-2017 02:36 PM  5 months agoPost 3
Richardmid1

rrProfessor

Leeds, England

My Posts: All  Forum  Topic

Standard gearing would defeat the purpose of the bigger motor surely?!

If it were me I would just use a couple of washers to pack the engine out a bit. Might be worth to also elongate the clutch stack holes to fine tune the alignment.

60% of the time, it works every time!

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR
WATCH
 1 page 486 views POST REPLY
Scorpion Power ProModeler
HelicopterGaui NX4 NX7Gaui NX4 › OK So did the OS55 install and now...
 Print TOPIC  Make Suggestion 

 3  Topic Subscribe

Saturday, July 29 - 12:44 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online