RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 324 views POST REPLY
ProModeler Scorpion Power
HelicopterMain Discussion › 5/6 mm Pinion Puller
08-17-2016 01:21 AM  12 months agoPost 1
Four Stroker

Elite Veteran

Atlanta

My Posts: All  Forum  Topic

I am looking for a 5 to 6 mm shaft pinion puller. Any recommendations ?

PM  EMAIL  GALLERY  Attn:RR
08-17-2016 03:07 AM  12 months agoPost 2
Ace Dude

rrProfessor

USA

My Posts: All  Forum  Topic

Have not used this myself, but perhaps this would work?

http://www.allerc.com/hyperion-coll...ers-p-2732.html

  

PM  EMAIL  GALLERY  Attn:RR
08-17-2016 03:11 AM  12 months agoPost 3
2LTime

Key Veteran

Walworth,NY

My Posts: All  Forum  Topic

http://www3.towerhobbies.com/cgi-bi...p?&I=LXYCE5&P=7

If you can't learn to do it well, learn to enjoy doing it badly.

PM  EMAIL  GALLERY  Attn:RR
08-17-2016 12:12 PM  12 months agoPost 4
Jeff polisena

Elite Veteran

westpalmbeachflorida usa

My Posts: All  Forum  Topic

I've never had a need for puller , heat up with heat gun and should slide off . There might be a need in your application .

I stole it ,flew it and gave it back ;)

PM  EMAIL  GALLERY  Attn:RR
08-17-2016 02:26 PM  12 months agoPost 5
GREYEAGLE

Elite Veteran

Flat Land's

My Posts: All  Forum  Topic

Cut a slot in a small piece of angle iron or mild steel to fit the shaft diameter. Slide the shaft into it.

USe it as a bridge / Set the bridge up on a few small blocks

Set the assembly on the deck of your drill press

Close the quill or chuck jaws

Gently give the shaft a push with the quill -

" Make sure " the Set screw is removes 1st "

Mark the shaft with a sharpie so you know the NEW re- position.

greyeagle

PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 324 views POST REPLY
ProModeler Scorpion Power
HelicopterMain Discussion › 5/6 mm Pinion Puller
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Wednesday, August 16 - 4:26 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online