RunRyder RC
 0  Topic Subscribe
WATCH
 1 page 458 views POST REPLY
Scorpion Power Scorpion Power
HelicopterRadio - Servo - Gyro - Gov - Batt › Align 610 current draw
05-16-2016 11:14 AM  17 months agoPost 1
Antsis

rrApprentice

Melbourne, Victoria, Australia

My Posts: All  Forum  Topic

Hi all.

I've just bought a used 700e V2 with Align 610 cyclic servos. I have a CC 10A bec set to 6V and I installed a TAGS mini fbl. I powered the model and noticed the fbl resetting after cycling the servos. I hooked up a Turnigy power meter and it was showing the cyclic servos pulling 18A causing the fbl reset. This was with only the swashplate conected. I know the 610's are current hungry, but this seems way too high. Do I have duff servos or should I ramp up the bec?

Ant

PM  EMAIL  GALLERY  Attn:RR  Quote
05-16-2016 01:05 PM  17 months agoPost 2
Heli Fanatix

rrVeteran

Fountain Valley, CA

My Posts: All  Forum  Topic

The CC 10A BEC is insufficient
- you need to use the CC BEC Pro
- ideal to use the 5.2v setting
- servo will have enough speed and torque
- the BEC will be more stable at that voltage

FYI
I have been using the DS610 for years on kontronik Internal BEC @ 5.6v for years on hard 3D.

- Scott

PM  EMAIL  GALLERY  Attn:RR  Quote
05-16-2016 03:50 PM  17 months agoPost 3
Santiago P

rrProfessor

South West, Ohio

My Posts: All  Forum  Topic

FYI,
The CC 10A Bec is only good for 5A with the standard J (servo) connector. You need a bigger connector in order to use all its capability.

And YES, those are very power hungry servos as indicated.

cheers

S

Team Minicopter - PeakAircraft.com
bavarianDEMON- Team Kontronik - Scorpion Motors-

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 458 views POST REPLY
Scorpion Power Scorpion Power
HelicopterRadio - Servo - Gyro - Gov - Batt › Align 610 current draw
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Monday, October 23 - 4:26 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online