RunRyder RC
 0  Topic Subscribe
WATCH
 1 page 474 views
Scorpion Power Scorpion Power
HelicopterCentury Radikal G20-30 N640 Hawk Predator › GV-1 Connection Stumped HELP
12-19-2003 09:11 PM  13 years agoPost 1
spool-it-up

rrApprentice

Oakwood Hills ILL..

My Posts: All  Forum  Topic

Well guys heres one for you i just purchased the
century Longranger kit and was about to install the
GV-1. Bought the alum. fan for it (running the OS-32)
Installed the magnet thats okay but no place to install the sensor
to even get close to the fan. This is a different setup from
other heli manufactors.
Century has the clutch bell on first then the fan,
so how do i get the sensor to pickup the mag in the fan
when there is no room for install of the sensor because the casing hits
the clutch bell.
Century guys what do i do and how will i attack this proplem.

John

PM  EMAIL  GALLERY  Attn:RR  Quote
12-19-2003 09:21 PM  13 years agoPost 2
MG

rrKey Veteran

California

My Posts: All  Forum  Topic

You have two choices;

* Cut the fan shroud around the area where you need to place the
sensor.

* Place the pick up magnet or pick up tape on the bottom of the clutch
bell.

Time wasted = Life not lived to the fullest.

PM  EMAIL  Attn:RR  Quote
12-19-2003 09:28 PM  13 years agoPost 3
spool-it-up

rrApprentice

Oakwood Hills ILL..

My Posts: All  Forum  Topic

ok i did cut the fan shroud already and still cannot get the
sensor close enough the casing on the sensor will not allow
me to get close enough without it hitting the cluthbell.
Can i remove the casing of the sensor and if i do go
to a install on the clutchbell should i purchase the alum. one.

John

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 474 views
Scorpion Power Scorpion Power
HelicopterCentury Radikal G20-30 N640 Hawk Predator › GV-1 Connection Stumped HELP
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Friday, November 24 - 10:56 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online