RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 569 views POST REPLY
Scorpion Power Scorpion Power
HelicopterBeginners Corner › Fly Bar Setting
12-19-2003 06:51 PM  13 years agoPost 1
Don Piotter

rrNovice

Largo, FL USA

My Posts: All  Forum  Topic

Hi.
I would like to find out about the setting of the fly bar. What I need to know is when the fly bar is installed and the servos are in neutral position , Will the paddles be perfectly flat or parallel.This is for an ECO 8. I had to replace the rod on the paddles and want to know the exact setup . Right now they are at a slight angle when servos are centered.The rod that holds the paddles has a pre drilled hole in each end , and the paddles have a screw that goes into the paddle and the paddle rod , so this puts them in a fixed position. I don't see anyway I can adjust the ballend linkage to make the paddles parallel.

Hope someone has an answer.

Don.

PM  EMAIL  HOMEPAGE  Attn:RR  Quote
12-20-2003 12:28 AM  13 years agoPost 2
cmdiduca

rrVeteran

Mt. Pocono, Pa

My Posts: All  Forum  Topic

Hey man I couldnt tell ya. You might want to post that question in the electrics section.
Chris

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 569 views POST REPLY
Scorpion Power Scorpion Power
HelicopterBeginners Corner › Fly Bar Setting
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Thursday, October 19 - 5:29 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online