RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 591 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Elec-Helicopters New or Limited Activity
MS Composit › Is 5cm of range of tail pitch slider enough???
12-17-2003 05:37 PM  13 years agoPost 1
jiri

rrApprentice

Aalborg, Denmark

My Posts: All  Forum  Topic

Hi,

I am new to Hornet and I am just finishing my Hornet II. I made the tail pitch slider very smooth now
but the range (when the tail blades are both
facing the same direction) is 3cm for the left
rudder and 5cm for the right one. Is it enough?
In particular for the right rudder there is still
something like 3mm space but when I try to go
until the end, I need to put lots of power to
do that. Everything goes absolutely smooth
without the E129 part but with it I cannot get
more then those 5cm ...

Will this be something to worry about?

Thanks,
Jiri

PM  EMAIL  HOMEPAGE  Attn:RR  Quote
12-19-2003 05:52 AM  13 years agoPost 2
Xnaron

rrApprentice

Edmonton, Alberta, Canada

My Posts: All  Forum  Topic

Should be more than enough... the manual only shows 3cm required. I found it needed more. 5cm should be fine. Just have the tail rotor shaft flush with the outside of the bearing opposite to the blades.

Brendin

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 591 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Elec-Helicopters New or Limited Activity
MS Composit › Is 5cm of range of tail pitch slider enough???
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Friday, October 20 - 6:17 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online