RunRyder RC
 3  Topic Subscribe
WATCH
 1 page 572 views POST REPLY
Scorpion Power ProModeler
12-17-2003 12:40 PM  13 years agoPost 1
dunbare

Veteran

Oak Ridge, TN

My Posts: All  Forum  Topic

I have two building question.

I disassembled the rotor head to double check that everything was in place. While reassembling it, I have run into two problems.

1. When installing one of the bell mixers to the main grip (step 8), it does not tighten all the way. It screws all the way in but never tightens. Is this normal, because the other side does. I used slow CA on both since this is metal to plastic.

2. When building the flybar yoke (step 10) the double ended ball link spins in it's socket after being tightened down. Is this normal, because it does not do this on the other side. Again I used CA for metal to plastic.

Should I worry about these parts coming apart in flight.

Frenzy 50, T-Rex SE, T-Rex 600N Pro

PM  EMAIL  Attn:RR
12-17-2003 01:20 PM  13 years agoPost 2
Foxden

Elite Veteran

Port Charlotte, FL. USA

My Posts: All  Forum  Topic

I'm building the Predator 60, and both parts went in all the way and are tight. I would contact Century, from what I've read on RR they are very helpful and stand behind there product and will most likely replace them.

Clyde

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR
12-17-2003 01:21 PM  13 years agoPost 3
rckrzy1

Elite Veteran

Hurst Texas

My Posts: All  Forum  Topic

sounds like you stripped both items, ...yikes. This is not good. You can not have balls moving or it will cut into the screws.



Wildcat Fuels

PM  EMAIL  GALLERY  Attn:RR
12-17-2003 01:24 PM  13 years agoPost 4
SteveH

rrProfessor

Texas

My Posts: All  Forum  Topic

Dunbare,

Neither of these bolts should spin and not tighten. From what you have posted, it sounds like they are both stripped. I suggest you contact Century, ask for tech support, and see what they suggest. I know this is not what you wanted to hear, but from what you have said, that's all the help I can give.

The government cannot give you anything without first taking it from someone else.

PM  EMAIL  GALLERY  Attn:RR
12-17-2003 06:49 PM  13 years agoPost 5
Lift

Elite Veteran

Houston, TX

My Posts: All  Forum  Topic

dunbare,
Ask for Dennis Cica and tell him Payton sent you. I personally think the flybar control arm will be fine if you CA'd it together. But, the Bell mixer should tighten down about as good as you would expect a metric bolt to hold in hardened plastic.

Call them up and see if they can send you a new grip. You will probably have to send your old one in. They will most likely send you a new and charge our card on file. Then, when the return comes in they will credit the card.

Cool?

PM  EMAIL  Attn:RR
WATCH
 1 page 572 views POST REPLY
Scorpion Power ProModeler
 Print TOPIC  Make Suggestion 

 3  Topic Subscribe

Tuesday, August 22 - 10:22 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online