RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 493 views POST REPLY
Scorpion Power Scorpion Power
HelicopterThunder TigerOther › need some input
12-17-2003 06:43 AM  13 years agoPost 1
Dave7999

rrNovice

Mobile,Alabama

My Posts: All  Forum  Topic

Im putting together a buddys new 50 and the the starter shaft takes some force to twist it ,it's real tight.Have any of you had this prob?I loosend the moter and the mout but still tight,installed the mast and it to feels tighter than it should be,does it just need to be ran?

Thanks
Dave

PM  EMAIL  Attn:RR  Quote
12-17-2003 11:14 AM  13 years agoPost 2
Al Magaloff

rrMaster

12,199 Posts- Enough Time Wasted. See Ya!

My Posts: All  Forum  Topic

Does not sound right Dave. The start shaft will turn backwards, with the use of two fingers, when everything is correct and lined up. Did you put the #18 thrust washer between the clutch bell inner bearing, and the snap ring/e-clip on the start shaft? Is the clutch/ liner done correctly? Do you have the fan screwed down against the front bearing of the motor, with nothing in between?

PM  EMAIL  Attn:RR  Quote
12-17-2003 11:23 AM  13 years agoPost 3
Andreas

rrVeteran

Sweden

My Posts: All  Forum  Topic

Check if you have the washer between the engine and fan mounte. If you have, put it away.
Also check that the maingear isn't upside down.

Cheers Andreas

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 493 views POST REPLY
Scorpion Power Scorpion Power
HelicopterThunder TigerOther › need some input
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Thursday, October 19 - 2:50 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online