RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 614 views POST REPLY
ProModeler Scorpion Power
HelicopterBergen R/C Helicopters › Observer bearing block
12-17-2003 12:14 AM  13 years agoPost 1
blimpguy

Senior Heliman

Pensacola Beach

My Posts: All  Forum  Topic

I was working on mounting the 2 screws that hold the clutch bearing block till the screws started to bind. I have a feeling it was the grip on
the 35mm that was binding in the hole of the frame. Does that assembly use non grip straight thread screws ? Just curious till the parts book arrives from Bergen.

Tks

Jeff

PM  EMAIL  HOMEPAGE  Attn:RR
12-17-2003 02:26 AM  13 years agoPost 2
Malorie

Elite Veteran

Paw squared, MI

My Posts: All  Forum  Topic

Those should be 4 3x10 SHCS with 3M flat washers. The holes are threaded. I don't have a manual handy at the moment to check the length on them but I think that's close.

Life's a journey, NOT a destination.

PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 614 views POST REPLY
ProModeler Scorpion Power
HelicopterBergen R/C Helicopters › Observer bearing block
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Sunday, August 20 - 10:09 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online