RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 973 views POST REPLY
ProModeler Scorpion Power
Helicopter
e-
Electric Motors-Controllers-ESC
Other › schulze future 11.20e help
12-16-2003 11:57 PM  13 years agoPost 1
RAPPY1

Heliman

lawton, ok

My Posts: All  Forum  Topic

could someone help me on the setup of the future 11.20e setup using a futaba 9c radio? the controller runs the motor but only about 100 rpm. i have raised my throttle points to 100 percent with no effect. the controller arms with the first thottle point at 0 then runs slow. thanks for any help.

PM  EMAIL  GALLERY  Attn:RR
12-18-2003 07:57 AM  13 years agoPost 2
ufon

Heliman

Prague, Czech Republic

My Posts: All  Forum  Topic

Probably your controller settings are wrong. Check your settings accordingly. For best performance and correct functionality you have to set some internal controller values such us:

- set heli mode
- set correct switching frequency for your motor e.g. 9kHz (see motor requirements or schulze http://www.schulze-elektronik-gmbh....de/gswit-de.pdf for a guide)
- set correct timing mode e.g.18 degrees

These settings are mandatory and have to be set precisely while they have direct impact on how your controller and motor run together.

PM  EMAIL  HOMEPAGE  Attn:RR
WATCH
 1 page 973 views POST REPLY
ProModeler Scorpion Power
Helicopter
e-
Electric Motors-Controllers-ESC
Other › schulze future 11.20e help
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Friday, August 18 - 11:55 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online