RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 586 views POST REPLY
Helicopter
e-
Electric Battery-Charger-pSupply
› iCharger 4010 Duo Display Issue
08-24-2014 04:35 PM  3 years agoPost 1
wayder

rrNovice

Warner Robins, GA

My Posts: All  Forum  Topic

Thank you to everyone for looking. I sent the charger back to Buddy RC and they replaced the charger no questions asked. It is working great!

V/R,
wayder

Has anyone else seen their display dim down to half brightness and very difficult to read? I went back into the brightness screen and the settings have not changed. Moving the bar to full brightness had very little effect. Both channels 1 & 2 are dimmed down to where it is hard to read. This started with Firmware version 2.14 and now that I have upgraded to version 2.15 there is an additional issue. The display not only goes dim but both channels read 2.35V with nothing connected and will slowly count down to zero volts. Also while the voltage is counting down the display will show a battery connected and not connected and switch back and forth until it finally shows no voltage.

V/R,
wayder

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 586 views POST REPLY
Helicopter
e-
Electric Battery-Charger-pSupply
› iCharger 4010 Duo Display Issue
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Sunday, May 27 - 8:56 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online