Okay, here is my issue, any input would be appreciated.
1st, I set up my throttle linkage, TRex 700n/YS120.
Then started to setup the align gov, using a VBar not the VBar gov.
I Plugged the throttle servo into the align gov from the gov plugged the 3 wire lead to the ESC/Collective input and put the yellow gov gain lead into the Aux2/Rudder channel of the vbar.
I also checked to make sure the magnets were installed properly and they were. Then I went to calibrate the gov with the throttle (linear throttle curve in normal). Then I setup my values in the governor menu in the DX8 normal -100 (off) S1 80% S2 90%. Yes I mapped the Aux2 channel and Flt mode switch to the governor menu (DX8).
Then I set standard V-Curves: 100/50/100 for S1 and S2 modes.
So here's my questions/concerns:
At low stick in all flight modes I get a red light meaning off, what's weird is that when I flip to S1 or S2 at low stick I get the same red light, but turns green once I get above 50% stick???? Keep in mind the S1/S2 are 100% at the top and bottom??
Also, In the VBAR software I have the Aux2 channel set to 6 is the correct??