The only way I can get the elevator to move is by moving the aileron stick on the tx.
that is not losing bind, that's losing the signal coming out of the transmitter. If you wiggle the stick and something hapens the system is bound, but obviously not working properly.
Let me ask a few questions:
--Are these New, never used before satelites?
--Where these satellites working ok previously?
--Do you have other sats you can try?
--Are you positive
you selected 1 SERVO NORMAL for swash type on your transmitter before the binding?
If so, try plugging the swash servos.
We are assuming the transmitter was working fine with other receivers prior to this issue.
I also notice that the elevator will not move when moving the collective stick
IT BETTER NOT! If you command collective only the collective bar should move on the DIAGNOSTIC dial. You said you had no servos plugged in, right?
After pluging the servos, you will set the correct swash type on the MIXER page of the 3SX software, and correct their direction.
Bavarian Demon Support Team
Team Minicopter - PeakAircraft.com
bavarianDEMON- Team Kontronik - Scorpion Motors-