|Tap or Snap|
Port Richey, Florida and Burlington, Wisconsin
My Posts: All Forum Topic
My Classified Feedback
Add Classified Feedback
This is a partial conversion that I never completed. It is excess to my needs. It has an AXI 5330/18 motor which is good for 10 cell lipo. It has the bearing blocks, 18T top gear, layshaft, and bottom pulley and belt. The paper taped to the front of the frame is a hookup diagram for a CCHV controller. This isnt plug and play you will need to experiment with a bottom pulley. A 48 tooth pulley from SDP with 10 cell should work well. It all depends on your cell count, blade size and what headspeed. This has been sitting in my scratch built 1/5 scale Lama as a testbed.
I do have a 10mm shaft and a Vario swash I will include since 10mm is to small for 1/5 scale.
$100.00 shipped. Paypal