RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 757 views POST REPLY
Helicopter
e-
Align
T-REX 150 › Landing Gear Fix
12-31-2013 05:28 AM  4 years agoPost 1
jschenck

rrProfessor

La Vista, NE.

My Posts: All  Forum  Topic

Broke the tab off the landing gear on a solid landing on carpet after I ran the pack down too far... (oops) -
I drilled it out and put a bolt in it that was just about the same size as the plastic post. The landing gear snapped as I threaded the bolt in so probably should have drilled it out slightly bigger which I can't do because I don't have a numbed drill set. Fixed this with a bit of CA and a spray of quick cure. The bolt was a loose fit into the frame so I wrapped a bit of tape around the bolt. Now it works well until I can order some spare LG. I hope the next batch from Align is not as brittle.

I did hover it around for a full pack and it was flying great. I didn't get brave enough to try any flips in my basement, lots of power though.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 757 views POST REPLY
Helicopter
e-
Align
T-REX 150 › Landing Gear Fix
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Thursday, May 24 - 3:34 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online