RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 430 views POST REPLY
HelicopterMain Discussion › axe cp3 servos to 3 in 1 receiver....help???
12-30-2013 08:08 AM  4 years agoPost 1
dannisdan

rrNovice

venice florida

My Posts: All  Forum  Topic

a nephew gave me his axe and all the servos are unplugged. can anyone tell me which ones plug where on the board?
thanks
dan

PM  EMAIL  Attn:RR  Quote
01-01-2014 01:43 AM  4 years agoPost 2
PilotPin

rrApprentice

Indiana -- USA

My Posts: All  Forum  Topic

What I have is the CPV3.

As you look at the helli from the right side the top connecter on the 3 in 1 is #1 bottom is #6. Front pins are ground, center is plus volts, and inside is signal.

#1 -- right side servo.
#2 -- left front servo.
#3 -- LPM
#4 -- single wire goes to signal pin.
#5 -- empty
#6 -- left rear servo.

Hope this can help you.

PM  EMAIL  GALLERY  Attn:RR  Quote
01-01-2014 04:20 PM  4 years agoPost 3
dannisdan

rrNovice

venice florida

My Posts: All  Forum  Topic

thanks, that is exactly what I wanted to know. thanks for the help

PM  EMAIL  Attn:RR  Quote
01-01-2014 04:56 PM  4 years agoPost 4
dannisdan

rrNovice

venice florida

My Posts: All  Forum  Topic

I have a right rear servo, a front left servo, and a rear LEFT servo. I am assuming the left rear servo goes to the # six pins. also the LPM coming out of the # three pins and goes no where and has a red wire that looks like it was soldered to something.

PM  EMAIL  Attn:RR  Quote
01-01-2014 08:40 PM  4 years agoPost 5
PilotPin

rrApprentice

Indiana -- USA

My Posts: All  Forum  Topic

My mistake on #6. should have been left rear servo. I changed it.

PM  EMAIL  GALLERY  Attn:RR  Quote
01-01-2014 08:56 PM  4 years agoPost 6
PilotPin

rrApprentice

Indiana -- USA

My Posts: All  Forum  Topic

The opposite end of the LPM goes to a connector from the E-board.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 430 views POST REPLY
HelicopterMain Discussion › axe cp3 servos to 3 in 1 receiver....help???
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Thursday, May 24 - 7:08 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online