RunRyder RC
 3  Topic Subscribe
WATCH
 1 page 701 views
Scorpion Power Scorpion Power
HelicopterGaui NX4 NX7Gaui NX4 › NX4 Maiden
12-16-2013 09:13 AM  3 years agoPost 1
islandbreeze

rrNovice

Pacific Islands

My Posts: All  Forum  Topic

I Maiden this baby yesterday and all went well. still in the breakin process and ran her rich with two tanks thru her. Everything held up as JC said it would. Thanks! one thing about this little motor I noticed is that you really have to burn the fuel out or else it will Hydolock on you.
I did a check after flight and the only thing so far is the main shaft bearing has some play. I will change them out to BOCA bearings later.

Cant wait to get her out again..

Aeromodelers Club of Guam

PM  EMAIL  GALLERY  Attn:RR  Quote
12-16-2013 10:11 AM  3 years agoPost 2
wrongler

rrProfessor

Brewerton, New York

My Posts: All  Forum  Topic

Do you have a shut off on the fuel line before the carb? If so, when you land, pinch off the fuel line and let it run out of fuel, that may prevent the Hydro-loc.

Bill Whittaker

PM  EMAIL  GALLERY  Attn:RR  Quote
12-16-2013 07:20 PM  3 years agoPost 3
islandbreeze

rrNovice

Pacific Islands

My Posts: All  Forum  Topic

Exactly what I am doing! hopefully after break-in and I lean out the low end it will go away, will see.

Aeromodelers Club of Guam

PM  EMAIL  GALLERY  Attn:RR  Quote
12-16-2013 07:28 PM  3 years agoPost 4
jczankl

rrKey Veteran

AZ

My Posts: All  Forum  Topic

Congrats on the Maiden

GAUI/Empire
Spinblades
PowerMaster Fuels
Graupner
Castle Creations
Scorpion Motor

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 701 views
Scorpion Power Scorpion Power
HelicopterGaui NX4 NX7Gaui NX4 › NX4 Maiden
 Print TOPIC  Make Suggestion 

 3  Topic Subscribe

Wednesday, November 22 - 3:01 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online