RunRyder RC
 7  Topic Subscribe
WATCH
 1 page 1756 views POST REPLY
Helicopter
e-
Synergy R/C
Synergy E5 › E5 Wiring!
01-05-2013 06:28 PM  5 years agoPost 1
thenewguy

rrElite Veteran

Corvallis, Oregon Where there is liquid sunshine!

My Posts: All  Forum  Topic

If you take your time you can hide the majority of wires.

Thanks,
Chris

PM  EMAIL  GALLERY  Attn:RR  Quote
01-05-2013 06:34 PM  5 years agoPost 2
Darren Lee

rrElite Veteran

Woodstock, GA

My Posts: All  Forum  Topic

Very nice Chris!

Team Synergy / Rail Blades / Morgan Fuel

PM  EMAIL  GALLERY  Attn:RR  Quote
01-05-2013 06:38 PM  5 years agoPost 3
thenewguy

rrElite Veteran

Corvallis, Oregon Where there is liquid sunshine!

My Posts: All  Forum  Topic

The tape on the servo will get replaced with something better. It's what I had for now.

Thanks,
Chris

PM  EMAIL  GALLERY  Attn:RR  Quote
01-05-2013 10:26 PM  5 years agoPost 4
Kevin Feil

rrVeteran

Newnan, Georgia, USA

My Posts: All  Forum  Topic

E5
Great Job Chris!!

Kevin

PM  EMAIL  GALLERY  Attn:RR  Quote
01-06-2013 12:56 AM  5 years agoPost 5
Taylor Myers

rrApprentice

vandalia ohio

My Posts: All  Forum  Topic

can i ask what the two smaller leads are coming off next the the main power leads on the castle?

PM  EMAIL  GALLERY  Attn:RR  Quote
01-06-2013 01:03 AM  5 years agoPost 6
Darren Lee

rrElite Veteran

Woodstock, GA

My Posts: All  Forum  Topic

BEC input leads.

Team Synergy / Rail Blades / Morgan Fuel

PM  EMAIL  GALLERY  Attn:RR  Quote
01-06-2013 01:16 AM  5 years agoPost 7
Taylor Myers

rrApprentice

vandalia ohio

My Posts: All  Forum  Topic

i see okay looks good

PM  EMAIL  GALLERY  Attn:RR  Quote
01-06-2013 03:10 AM  5 years agoPost 8
bart2546

rrVeteran

Canal Winchester, OH - USA

My Posts: All  Forum  Topic

That is very nice and clean. Great job!

Regards, Brandon Bartolomucci; Team Synergy; Team Scorpion; & Team Bavarian Demon; AMA# L939231

PM  EMAIL  GALLERY  Attn:RR  Quote
01-06-2013 03:45 AM  5 years agoPost 9
Kevin Dalrymple

rrKey Veteran

Indianapolis

My Posts: All  Forum  Topic

I like the leads on the BEC as well. I am going to do the to my E7. Like the wire job.

PM  EMAIL  GALLERY  Attn:RR  Quote
01-06-2013 03:48 AM  5 years agoPost 10
thenewguy

rrElite Veteran

Corvallis, Oregon Where there is liquid sunshine!

My Posts: All  Forum  Topic

The 2 leads are BEC leads. It works out great to trim the ESC cover just a little bit, then solder the BEC lead to the ESC main power wires. Makes for a much cleaner system and is easy to do.

This is actually a friends/customers E5 I have been helping him with. Planning on a test flight here soon.

Thanks for the compliments.
Chris

PM  EMAIL  GALLERY  Attn:RR  Quote
01-06-2013 10:48 PM  5 years agoPost 11
Dan Minick

rrKey Veteran

Columbus, WI

My Posts: All  Forum  Topic

here is my E5, decided to try a mini vbar i had with sats. very clean, i am very happy to report the max vibration recorded on the vbar has been "8" at 2450HS

PM  EMAIL  GALLERY  Attn:RR  Quote
01-06-2013 10:49 PM  5 years agoPost 12
Taylor Myers

rrApprentice

vandalia ohio

My Posts: All  Forum  Topic

as anyone tried the talon 90 esc with built in bec on 6s?

PM  EMAIL  GALLERY  Attn:RR  Quote
01-08-2013 12:05 PM  5 years agoPost 13
bart2546

rrVeteran

Canal Winchester, OH - USA

My Posts: All  Forum  Topic

A few people have discussed the option of the talon 90 however the general consensus as stated by Matt is this: If you are going to push the limits the 90 will not work for you as it will be too much load in it. If you're a sport flyer it will "PROBABLY" work fine.

As most have agreed, just go with the 120 and be done with it and have no worries. Even if you fly sport now and plan to progress there's no reason to buy twice. You need head room for spikes in power and the 90 would put you directly on the threshold from the get go.

Regards, Brandon Bartolomucci; Team Synergy; Team Scorpion; & Team Bavarian Demon; AMA# L939231

PM  EMAIL  GALLERY  Attn:RR  Quote
01-08-2013 02:04 PM  5 years agoPost 14
Taylor Myers

rrApprentice

vandalia ohio

My Posts: All  Forum  Topic

yes but with the 120 i have to run a seperate rx pack which adds a lot of weight. and running a 6s 5000 i dont see how you can push the threshold of a 90 amp esc. guys used to run 80 on a 12s setup on a 90e?

PM  EMAIL  GALLERY  Attn:RR  Quote
01-08-2013 07:08 PM  5 years agoPost 15
bart2546

rrVeteran

Canal Winchester, OH - USA

My Posts: All  Forum  Topic

I suppose it would depend on what motor and pinion you're running but the 120 was recommended by Matt as a sure thing where the 90 has potential to have the limitations reached especially in hard flight. The end decision of course is ultimately up to you.

Regards, Brandon Bartolomucci; Team Synergy; Team Scorpion; & Team Bavarian Demon; AMA# L939231

PM  EMAIL  GALLERY  Attn:RR  Quote
01-09-2013 01:17 AM  5 years agoPost 16
1Installer

rrNovice

Ramsey, MN- USA

My Posts: All  Forum  Topic

The lower voltages require more current to operate. You could probably get by on a 12s setup with an 80. The 120 is perfect in that you can go either 6s or 12s on the same ESC.

PM  EMAIL  Attn:RR  Quote
01-09-2013 09:12 PM  5 years agoPost 17
thenewguy

rrElite Veteran

Corvallis, Oregon Where there is liquid sunshine!

My Posts: All  Forum  Topic

Finalized all the wiring.

Please don't steal my thread.

Thanks,
Chris

PM  EMAIL  GALLERY  Attn:RR  Quote
01-10-2013 02:06 PM  5 years agoPost 18
Chris Sexton

rrApprentice

Columbus, OH

My Posts: All  Forum  Topic

Looks great! Now lets see some flight video.

Chris Sexton
Synergy Factory Specialist / Team Scorpion

PM  EMAIL  GALLERY  Attn:RR  Quote
01-10-2013 07:50 PM  5 years agoPost 19
thenewguy

rrElite Veteran

Corvallis, Oregon Where there is liquid sunshine!

My Posts: All  Forum  Topic

We're going to beat up on it this weekend. I'll try to remember to get some video.

Thanks,
Chris

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 1756 views POST REPLY
Helicopter
e-
Synergy R/C
Synergy E5 › E5 Wiring!
 Print TOPIC  Make Suggestion 

 7  Topic Subscribe

Thursday, April 26 - 6:19 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online