RunRyder RC
 3  Topic Subscribe
WATCH
 1 page 2732 views
Scorpion Power Scorpion Power
HelicopterFlybarless Rotor Head SystemsAlign 3G › Align 3GX governor
01-01-2013 07:08 AM  4 years agoPost 1
edwelds

rrApprentice

hartford,ky-usa

My Posts: All  Forum  Topic

I have a Titanx50 flybarless nitro,Align 3GX and a Futaba T8FG tx.The instructions are very limited on seting up the gov.Should the green gov light come on? It says to set the head speed by % on tx.How do you know what% ?

PM  EMAIL  GALLERY  Attn:RR
01-01-2013 07:26 PM  4 years agoPost 2
mr dave

rrNovice

Thames, NZ

My Posts: All  Forum  Topic

When using the 3GX software, find the govoner set up page/tab, have everything plugged in and on, you need to put in your gear ratio, (ie trex 600 is 8.5) and it will caculate engine/rpm and your head speed by what % your GOV CH is set at. the green light must be on, green=on, red=off.

PM  EMAIL  GALLERY  Attn:RR
01-01-2013 07:30 PM  4 years agoPost 3
resa man

rrNovice

uk

My Posts: All  Forum  Topic

Best to start with a low % and try the head speed
To measure it correctly you with need a tacho as % is only as a guide to your transmitter
I usually can hear the correct head speed of my helis but use a tachometer for helis if you find this a bit of a challenge
Also depends on the style of flying

PM  EMAIL  GALLERY  Attn:RR
01-04-2013 10:39 PM  4 years agoPost 4
crashagain

rrApprentice

Redding

My Posts: All  Forum  Topic

3GX needs to know the maximum and minimum positions of the throttle and mechanical travel range, you have to set this function whether you use it or not.
Note: Swashplate setup must be completed prior to performing throttle calibration procedure.

1. Reset throttle curve and pitch curve to default 0-50-100.
2. Confirm the transmitter is powered up, and throttle stick is at lowest position.
3. Press and hold the SET button while powering up the receiver until all 1~5 LED lights up. Release the SET button and GOV red LED will light up.
4. Push the throttle stick on transmitter to the maximum top, and in a few moments LED will go off and system power cycles, indicating the completion of setup process.

In the Gov menu of the radio, turn it on and setup the 3 settings for what you want. Normal, should be "0" this will turn off the gov, you will see the light stay red, then in the Idle up's start around 75% for 1 and 85% for 2, this is what I am running on mine.Also you need to straight line your throttle curves for idle 1 and 2, I have mine at 100.

Velocity 50 FBL, Trex 600 FBL, Frenzy V2 FBL

PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 2732 views
Scorpion Power Scorpion Power
HelicopterFlybarless Rotor Head SystemsAlign 3G › Align 3GX governor
 Print TOPIC  Make Suggestion 

 3  Topic Subscribe

Tuesday, November 21 - 10:27 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online