RunRyder RC
 3  Topic Subscribe
WATCH
 1 page 832 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Blade
Blade 130 › Quad bearings tail case.
08-27-2012 06:09 PM  5 years agoPost 1
integy2

rrVeteran

California USA

My Posts: All  Forum  Topic

Blade BLH3727 1.5x4x1.12 Bearings (2)
Easy to do less than 5 mins.
Vibration free

(Good flight end up with ...... big smile :D)

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
08-27-2012 06:54 PM  5 years agoPost 2
jschenck

rrProfessor

La Vista, NE.

My Posts: All  Forum  Topic

these went into the tail blade grips?

PM  EMAIL  GALLERY  Attn:RR  Quote
08-27-2012 07:06 PM  5 years agoPost 3
fla heli boy

rrKey Veteran

cape coral, florida

My Posts: All  Forum  Topic

looks like inner and outer bearing in each side of the case... right (4 total)??

PM  EMAIL  GALLERY  Attn:RR  Quote
08-27-2012 07:12 PM  5 years agoPost 4
integy2

rrVeteran

California USA

My Posts: All  Forum  Topic

Tail case. Stock came with 1.5x4x2 Flanged Bearing (2)
I add BLH3727 1.5x4x1.12 bearings each side.
Dab green loctite around the edge. Let it sit overnight. Done.

(Good flight end up with ...... big smile :D)

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
08-27-2012 10:54 PM  5 years agoPost 5
spoolemup

rrApprentice

NJ - USA

My Posts: All  Forum  Topic

Did you elongate the one flat spot on the tail output shaft (TOS), that's holding the retainer collar??

If not, only one setscrew is doing the job, unless there is enough space for the set screw to lock into the groove on the TOS.

You don’t need your TOS flying out when you give a hard nose left.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 832 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Blade
Blade 130 › Quad bearings tail case.
 Print TOPIC  Make Suggestion 

 3  Topic Subscribe

Friday, October 20 - 5:21 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online