RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 740 views POST REPLY
HelicopterAerial Photography and Video › Need help with Helicommand HC-3SX
01-24-2012 04:01 AM  6 years agoPost 1
MAVRICK

rrVeteran

Northwest Georgia

My Posts: All  Forum  Topic

Ok so I have a T-Rex 700e with a camera mount from PhotoShip One. I am using s DX8 radio with a AR8000RX. I just got in a Helicommand HC-3SX flight stabilization unit that was recommend by PhotoShip One and i'm having trouble with the wire setup.

I got the cyclic servos setup as per the manual but does the rudder servo plug into the very bottom (tail servo) port, and the single yellow wire from the top wire loom on the HC unit goes into the rudder channel of the rx? The head gyro (green) and taill gyro (gray) are for the gain sensitivity? So the gray wire goes into the gear channel and the green wire goes into the Aux 2 channel?

The Bec goes into the battery/ head servo 4 port of the HC unit? So where does the ESC plug into? Does it just stay in the throttle channel of the RX?

If someone could help me with this I'd be very grateful.

Thank you for your time
VegasFreak

PM  EMAIL  GALLERY  Attn:RR  Quote
01-25-2012 03:38 AM  6 years agoPost 2
Stephen Born

rrElite Veteran

USA

My Posts: All  Forum  Topic

Ask the question on this topic forum. A lot of guys will help.

https://rc.runryder.com/helicopter/t680660p1/

PM  EMAIL  Attn:RR  Quote
01-25-2012 04:53 AM  6 years agoPost 3
F1 Rocket

rrKey Veteran

Melbourne, Florida USA

My Posts: All  Forum  Topic

You have it right. When using a standard receiver with the supplied interface cable the ESC will go to the throttle channel of the RX.

Danny

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 740 views POST REPLY
HelicopterAerial Photography and Video › Need help with Helicommand HC-3SX
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Monday, May 28 - 12:40 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online