RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 419 views POST REPLY
Scorpion Power Scorpion Power
HelicopterGasser Model RC HelicoptersOther › Spectra elevator control rod
12-18-2011 01:31 PM  5 years agoPost 1
flyinfriend

rrApprentice

North American continent

My Posts: All  Forum  Topic

Hi,

I am rebuilding my Spectra after an unplanned auto, servo arm snapped on throttle. I rebuilt a couple of servos and I'm re-installing them. I noticed the rod going from the elevator bellcrank to the elevator servo has an upward slant from back to front. I am using the Futaba Large servo wheel on all servos and this is the only one that is not in-line. Doesn't this throw off the geometry and how much the swash elevator responds in relation to the aileron servos when adding collective??

Thanks

PM  EMAIL  GALLERY  Attn:RR
12-18-2011 02:25 PM  5 years agoPost 2
ocr231

rrApprentice

Webster MA

My Posts: All  Forum  Topic

Hi Tom,
That's ok.Just make sure that your servo wheel and bell crank are 90%.Then level you swash plate like you normally would.

PM  EMAIL  GALLERY  Attn:RR
12-18-2011 10:05 PM  5 years agoPost 3
flyinfriend

rrApprentice

North American continent

My Posts: All  Forum  Topic

Thanks a lot Adam, makes sense now.

PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 419 views POST REPLY
Scorpion Power Scorpion Power
HelicopterGasser Model RC HelicoptersOther › Spectra elevator control rod
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Wednesday, September 20 - 1:05 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online