RunRyder RC
 3  Topic Subscribe
WATCH
 1 page 577 views
Scorpion Power Scorpion Power
HelicopterOutrage 50-90-Nitro › Aerospire govenor magnets need help!
12-03-2011 07:02 AM  5 years agoPost 1
leeh1979

rrNovice

lawrence, Kansas -​usa

My Posts: All  Forum  Topic

I just bought this govenor and I was told that when the magnets are stuck together mark 1 with a red marker and the other with a black marker. and then put them in the velocity bell housing. With the marker side facing up. Well I did that and when I go to test sensor it only picks up one magnet it doesn't see both. Is the sensor suppost to only see one magnet? Or was I only suppost to put in one magnet in the bell housing because I already glued the magnets in and now I can't get them out of the housing. What should I do?

PM  EMAIL  HOMEPAGE  Attn:RR  Quote
12-03-2011 09:48 AM  5 years agoPost 2
Ace Dude

rrProfessor

USA

My Posts: All  Forum  Topic

Check the instructions to verify the correct installation procedure:

http://aerospire.com/support.html

If the magnet was installed using epoxy, you may be able to use the tip of a hot soldering iron to loosen the glue to get the magnet out, but be aware that heating the magnet will also de-magnetize it. Thus, you may want to discard it if you use heat to remove it.

  

PM  EMAIL  GALLERY  Attn:RR  Quote
12-03-2011 10:10 AM  5 years agoPost 3
p00rboi

rrNovice

Rockville, VA-USA

My Posts: All  Forum  Topic

You have it installed correctly. The sensor only picks up one magnet the other is there for balance.

PM  EMAIL  Attn:RR  Quote
12-03-2011 01:32 PM  5 years agoPost 4
Zaneman007

rrElite Veteran

Texas - USA

My Posts: All  Forum  Topic

You only need one magnet. The other is to balance it all out.

As stated above, you have done it correctly.

Old Guys Rule!

PM  EMAIL  GALLERY  Attn:RR  Quote
12-03-2011 09:20 PM  5 years agoPost 5
leeh1979

rrNovice

lawrence, Kansas -​usa

My Posts: All  Forum  Topic

Ok thanks guy's!

PM  EMAIL  HOMEPAGE  Attn:RR  Quote
WATCH
 1 page 577 views
Scorpion Power Scorpion Power
HelicopterOutrage 50-90-Nitro › Aerospire govenor magnets need help!
 Print TOPIC  Make Suggestion 

 3  Topic Subscribe

Thursday, November 23 - 6:53 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online