RunRyder RC
 1  Topic Subscribe
WATCH
 2 pages [ <<    <    ( 1 )     2     NEXT    >> ] 1046 views
Scorpion Power Scorpion Power
HelicopterFlybarless Rotor Head SystemsAlign 3G › 3G link usb question, Also v2.1 or v3
12-01-2011 04:17 AM  5 years agoPost 1
flydan

rrApprentice

lawrenceville GA

My Posts: All  Forum  Topic

Can you set it up with the cable link?
I really HATE the travel setup on the tail, Rather use the usb,
Also v2.1 or v3?

PM  EMAIL  Attn:RR  Quote
12-01-2011 12:09 PM  5 years agoPost 2
jsenicka

rrProfessor

Eagle River, WI

My Posts: All  Forum  Topic

you cannot setup with the USB, only view for the tail travels.

Jim Senicka
Team Manager, GrandRC Flight Team

PM  EMAIL  GALLERY  Attn:RR  Quote
12-01-2011 12:11 PM  5 years agoPost 3
flydan

rrApprentice

lawrenceville GA

My Posts: All  Forum  Topic

So your telling me I couldnt change the travels in the program?

PM  EMAIL  Attn:RR  Quote
12-01-2011 12:17 PM  5 years agoPost 4
flydan

rrApprentice

lawrenceville GA

My Posts: All  Forum  Topic

Wow just seen that...
any tips on setting the tails travel limit?

PM  EMAIL  Attn:RR  Quote
12-01-2011 01:12 PM  5 years agoPost 5
jsenicka

rrProfessor

Eagle River, WI

My Posts: All  Forum  Topic

yeah. Use the transmitter. pretty simple really.

My setup sequence.
- run through setup one time with servo unplugged to verify/setup 760/1520 usec and digital/analog
- plug in servo and allow normal initialization. Check for proper servo direction on transmitter input (reverse on TX as needed) and also gyro sense. If wrong gyro sense, fix on next pass.
- Enter setup mode again.
- leave 760/1520 alone
- leave in digital
- set correct gyro sense direction if needed
- set throws
- slowly sweep left till you reach desired end point.
- pause 2 seconds
- slowly sweep right to desired end point
- pause 2 seconds
- set delay/heli size
- for big helis, you want green light
move rudder stick just off center till light turns green (just the tiniest bit off center). Hold that stick deflection and hit setup one more time to exit.

I went to Navy basic training as a young guy when things stuck in my brain. You step off marching on your left foot. The tail end point setup starts off with left followed by right.

Jim Senicka
Team Manager, GrandRC Flight Team

PM  EMAIL  GALLERY  Attn:RR  Quote
12-01-2011 03:44 PM  5 years agoPost 6
flydan

rrApprentice

lawrenceville GA

My Posts: All  Forum  Topic

See the problem I had is It would never,
keep the input on the throw.
Dose it have to be in rate or HH mode

PM  EMAIL  Attn:RR  Quote
12-01-2011 05:25 PM  5 years agoPost 7
flydan

rrApprentice

lawrenceville GA

My Posts: All  Forum  Topic

Set.. very nice. I set it up wrong the whole time. also
whats better v2.1 or 3

PM  EMAIL  Attn:RR  Quote
12-01-2011 06:13 PM  5 years agoPost 8
Zaneman007

rrElite Veteran

Texas - USA

My Posts: All  Forum  Topic

Version 3 for me

Old Guys Rule!

PM  EMAIL  GALLERY  Attn:RR  Quote
12-01-2011 06:15 PM  5 years agoPost 9
flydan

rrApprentice

lawrenceville GA

My Posts: All  Forum  Topic

Why, dose the oscillation stop

PM  EMAIL  Attn:RR  Quote
12-01-2011 11:14 PM  5 years agoPost 10
jsenicka

rrProfessor

Eagle River, WI

My Posts: All  Forum  Topic

3.0 is by far the best. Leave every setting at default. Set gain dials till you show about 140 on the settings screen for aileron and elevator. And about 50 on tail gain.

Jim Senicka
Team Manager, GrandRC Flight Team

PM  EMAIL  GALLERY  Attn:RR  Quote
12-01-2011 11:31 PM  5 years agoPost 11
flydan

rrApprentice

lawrenceville GA

My Posts: All  Forum  Topic

Did it stop all the nodding and crap

PM  EMAIL  Attn:RR  Quote
12-02-2011 12:10 AM  5 years agoPost 12
wifeorheli

rrElite Veteran

reno, nevada usa

My Posts: All  Forum  Topic

+1 v3.0

Novarossi Motors U.S.A
www.PlanetHobby.com
Team Align
GrandRc.com
ZRC U.S.A. "PushGlo, SwitchGlo"

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
12-02-2011 12:12 AM  5 years agoPost 13
flydan

rrApprentice

lawrenceville GA

My Posts: All  Forum  Topic

Explain why, dose it feel more connected, crisp,
stops the wobble

PM  EMAIL  Attn:RR  Quote
12-02-2011 12:56 AM  5 years agoPost 14
wifeorheli

rrElite Veteran

reno, nevada usa

My Posts: All  Forum  Topic

one word for me "TAIL" i always had a problem with the tail on the 3g bad tendecies ect.. could never track them down. v3.0 was better and could tell right after upgrade. Honastly never had problems with anything else in any of the other versions. Just the tail. Im now flying 3gx and i must say they did there homework the thing is rock solid tail,cyclic, everything. Load v3.0 and go from there. I have learned from my friend who flies for align thwhat your fighting to do is get the most gain possible without any bad tendicies. This has to do with the tail to. Upgrade and start tuning it. If you need anything shoot me a pm!!

Novarossi Motors U.S.A
www.PlanetHobby.com
Team Align
GrandRc.com
ZRC U.S.A. "PushGlo, SwitchGlo"

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
12-02-2011 01:47 AM  5 years agoPost 15
flydan

rrApprentice

lawrenceville GA

My Posts: All  Forum  Topic

pm sent

PM  EMAIL  Attn:RR  Quote
12-02-2011 02:47 AM  5 years agoPost 16
flydan

rrApprentice

lawrenceville GA

My Posts: All  Forum  Topic

Those who are keeping up with this, when upgrading to v3
do you need to set pitch again 0 pitch and all, re center swash,
all the time taking stuff, because if SO i wont update

PM  EMAIL  Attn:RR  Quote
12-02-2011 03:36 AM  5 years agoPost 17
jsenicka

rrProfessor

Eagle River, WI

My Posts: All  Forum  Topic

yes you need to redo all setup.
yes you need to do it anyway. Tail is 10x better.
yes you need to not bitch about it

Jim Senicka
Team Manager, GrandRC Flight Team

PM  EMAIL  GALLERY  Attn:RR  Quote
12-02-2011 03:38 AM  5 years agoPost 18
flydan

rrApprentice

lawrenceville GA

My Posts: All  Forum  Topic

My tail is nice on the v2.1 I am worried about the cyclic,
Also I was told you can set pitch in the limit, I was having fits getting both ends correct, So all you do when that happens is set high end and low end travel?
And on the last comment, Flydan slaps you with a firetruck lol

PM  EMAIL  Attn:RR  Quote
12-05-2011 10:59 PM  5 years agoPost 19
flydan

rrApprentice

lawrenceville GA

My Posts: All  Forum  Topic

Holy cow!!! My 3g on v3 feels like a brand new heli.
tail is so nice, even needed to ADD gain to it.. updated it and didnt even have to re do my pitch links!

PM  EMAIL  Attn:RR  Quote
12-07-2011 01:18 AM  5 years agoPost 20
wifeorheli

rrElite Veteran

reno, nevada usa

My Posts: All  Forum  Topic

+1

Novarossi Motors U.S.A
www.PlanetHobby.com
Team Align
GrandRc.com
ZRC U.S.A. "PushGlo, SwitchGlo"

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 2 pages [ <<    <    ( 1 )     2     NEXT    >> ] 1046 views
Scorpion Power Scorpion Power
HelicopterFlybarless Rotor Head SystemsAlign 3G › 3G link usb question, Also v2.1 or v3
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Tuesday, November 21 - 11:16 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online