T-Rex 700LE BNF
T-Rex 700 LE kit - bought brand new all pre built parts were taken apart and re assembled with loctite to ensure they do not come apart. Has typical carbon frames, aluminum boom wrapped with carbon, has chrome skids, has crank sensor for governor.
Helicopter originally had a align 91 motor, that was sold to a family member to help them get a 700 going, that motor was replaced with the O.S.
Upgraded frame screws - stock ones tend to strip out
O.S. 91 HZ-R regulated motor - bought brand new and has between 25-35 flights on it never run lean never run to its full capacity, only 20% cool power fuel run through motor. Original glow plug still installed.
Standard Align 91 Muffler/pipe - small dent in side from transportation to the field.
Still a Flybar helicopter - stock align paddles (yup i am not a flybarless fan yet)
693 Edge carbon fiber blades - bought brand new from B&B Hobbies in Riverview florida.
Align 2-1 regulator on/off switch remote glow
DS 610 Digital servos throughout the heli
DS 650 Digital servo for the Tail
Spartan DS760 Heading Lock Gyro combo, recently installed (upgraded from gy401)
RCE-G600 Standard Align Governor
Align Starter - approximately 2 years old, still in perfect working condition battery included
Included is also a AR7000 Specktrum receiver
Two flight packs included - original stock align pack as well as additional Thunderpower flight pack
Also have an additional aftermarket canopy - either a Fusano or Canomod included with deal
Helicopter also comes with a canomod Aston hybrid canopy that is currently my stock flying canopy / in addition the above canopy is also included.
I am asking 900.00 plus shipped to your location...any reasonable offers will be entertained...no low balling please....