RunRyder RC
 3  Topic Subscribe
WATCH
 1 page 940 views POST REPLY
10-25-2011 05:16 AM  6 years agoPost 1
PilotPin

rrApprentice

Indiana -- USA

My Posts: All  Forum  Topic

I'm building a new Aurora. Just wondering how everyone sets up the pressure line on the fuel tank. Do you use the brass line ran in the tank or drill the hole in the top of the tank and use the threaded fitting. I would like to use the threaded fitting. Would the threads wear out from the vibration?

PM  EMAIL  GALLERY  Attn:RR  Quote
10-25-2011 12:05 PM  6 years agoPost 2
GraZer

rrApprentice

Cape Town, South Africa

My Posts: All  Forum  Topic

Most people go for the threaded fitting on the top of the tank. The fit is very good and seems to have no issues in the durability department. Rather drill out less to start with to ensure the threads sit tight.

PM  EMAIL  GALLERY  Attn:RR  Quote
10-25-2011 12:56 PM  6 years agoPost 3
Ville Erkkilä

rrApprentice

Oulu, Finland

My Posts: All  Forum  Topic

In my first tank I used the threaded fitting. However after quite a many flights tank started to develop small crack where the fitting goes. I managed to seal it but after some time tank started to leak again. After this I bought new tank and used brass tubing. It was little bit tricky to install but at least it won't leak.

PM  EMAIL  GALLERY  Attn:RR  Quote
10-26-2011 02:17 AM  6 years agoPost 4
FLYERCLD

rrVeteran

Proctor, Arkansas

My Posts: All  Forum  Topic

I Installed by the manual with no issues.

MA Whiplash Nitro
Avant Aurora X2
OS 91 HZ
YS120
VBAR BlueLine
DX18
AMA L504443

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 940 views POST REPLY
 Print TOPIC  Make Suggestion 

 3  Topic Subscribe

Monday, April 23 - 6:56 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online