RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 1156 views POST REPLY
Scorpion Power Scorpion Power
HelicopterClassifieds - Miscellaneous Sold  Hirobo SDX parts
09-08-2011 12:28 AM  6 years agoPost 1
Bouchah

rrKey Veteran

Willow Spring, N. Carolina USA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

I chose not to rebuild, so here are the parts that are left.
I will try my best to describe any problems with all parts in this post. Most of the parts are without issue. Any questions pleas PM me.
Asking price was $175, $170 NOW $125 For all parts shipped in the US.. I am willing to seperate If you only want a certain part. My EBay feedback is 100%, tamari42000

-SDX SWM Instruction Manual (Great condition with the exception of the red scribble mark on the cover and a few notes I wrote on the inside).

-Rudder control rod, POM pipe, rudder guide, rudder control guide 3 rings, (Rudder control rod is bent, the rest of the parts are fine)
Tail Boom Braces (both are straight, ends are good).

-Flybar NIP (only one) 0402-055

-89 tooth black Delrin main gear, one way bearring, plastic one way bearring housing ( The Delrin gear has two teeth that something rubbed on them, there are small marks on the two teeth but the shapes of the teeth are still in tact. About 15 teeth over from that there are four teeth that have small marks on them, on the top side of the gear. The clutch bell pinion gear rotates on the main gear fine. I would not hesitate to use the Delrin gear).

-Fuel Tank with clunk, Header Tank with clunk and mounts(fuel tank is in good condition, no cracks. Header tank, top right, left in pic, mounting loop was stretched and broke.

-Tail assembly, tail blades, belt (Not sure if the tail shaft is bent, left half of the tail case is cracked where the boom slides into it. All other parts appear to be fine from what I can tell.

-Swash plate

-Fins, horizontal & vertical, horizontal fin mounting clamp to boom (Vertical fin is not broken, horizontal fin has a crack near one of the bolt holes as well as a crack on the back edge of the fin in the center).

-Yoke assembly, Center hub, washout block ( The feathering spindle appears to be bent, the head button has two cracks in the outer edge where holes are at, will not cause problems if used. Center hub is good has bearings still installed. Washout block is good).

-Other misc parts, rods, motor mount, blade grips, paddles, counter gear assembly ( Blade grips have bearings zip tied still in place, bearings all seem good except the main shaft ones those were shot).

-Canopies, Fiberglass painted teal/black, stock white with new sticker sheet (white canopy is original out of kit, sticker sheet is same. The teal fiberglass canopy is one of the first generation canopies that the front mounting holes were not drilled in the correct position. It may be able to be modified to make it fit good.

Blade 130x (5)
Trex 550 V2 (18)
Shuttle ZXX
Freya Xspec (20)

PM  EMAIL  GALLERY  Attn:RR  Quote
09-09-2011 01:24 AM  6 years agoPost 2
Bouchah

rrKey Veteran

Willow Spring, N. Carolina USA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

Bump for a price drop.

Blade 130x (5)
Trex 550 V2 (18)
Shuttle ZXX
Freya Xspec (20)

PM  EMAIL  GALLERY  Attn:RR  Quote
09-11-2011 03:35 PM  6 years agoPost 3
Bouchah

rrKey Veteran

Willow Spring, N. Carolina USA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

Bump for a price drop.

Blade 130x (5)
Trex 550 V2 (18)
Shuttle ZXX
Freya Xspec (20)

PM  EMAIL  GALLERY  Attn:RR  Quote
10-17-2012 01:25 PM  5 years agoPost 4
Bouchah

rrKey Veteran

Willow Spring, N. Carolina USA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

Still have these, entertaining offers!

Blade 130x (5)
Trex 550 V2 (18)
Shuttle ZXX
Freya Xspec (20)

PM  EMAIL  GALLERY  Attn:RR  Quote
10-17-2012 03:24 PM  5 years agoPost 5
IvanBorrelly

rrNovice

Doral, FL, USA

My Posts: All  Forum  Topic

My Classified Activity
No Classified Feedback
Add Classified Feedback

How much for the canopies? each one or both?

PM  EMAIL  Attn:RR  Quote
03-15-2013 01:22 AM  4 years agoPost 6
Bouchah

rrKey Veteran

Willow Spring, N. Carolina USA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

I had my price on this stuff, lets hear what you will pay for it! Make some offers! Would like it to all go in one shot.

Blade 130x (5)
Trex 550 V2 (18)
Shuttle ZXX
Freya Xspec (20)

PM  EMAIL  GALLERY  Attn:RR  Quote
03-16-2013 02:17 AM  4 years agoPost 7
Bouchah

rrKey Veteran

Willow Spring, N. Carolina USA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

Save some green sale, anybody, any offers!

Blade 130x (5)
Trex 550 V2 (18)
Shuttle ZXX
Freya Xspec (20)

PM  EMAIL  GALLERY  Attn:RR  Quote
03-18-2013 11:48 PM  4 years agoPost 8
Bouchah

rrKey Veteran

Willow Spring, N. Carolina USA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

Still looking for some offers, I have to go to the post office in the morning and would like to take this stuff with me.
I am moving on Friday and dont want to move it again!

Blade 130x (5)
Trex 550 V2 (18)
Shuttle ZXX
Freya Xspec (20)

PM  EMAIL  GALLERY  Attn:RR  Quote
03-30-2013 04:39 PM  4 years agoPost 9
fastrc1

rrKey Veteran

Brooklyn, NY-USA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

PM sent.

RIP Roman Pirozek Jr.
Team SRW Comp
Zeal Blades U.S. Flight Team
HRP
Team CanoMod

PM  EMAIL  GALLERY  Attn:RR  Quote
03-30-2013 05:27 PM  4 years agoPost 10
Bouchah

rrKey Veteran

Willow Spring, N. Carolina USA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

Everything is sold.

Blade 130x (5)
Trex 550 V2 (18)
Shuttle ZXX
Freya Xspec (20)

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 1156 views POST REPLY
Scorpion Power Scorpion Power
HelicopterClassifieds - Miscellaneous Sold  Hirobo SDX parts
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Classifieds › HELP-FAQ
Attention buyers! For sellers to Add Classified Feedback you need to Post Reply in the seller’s topic thus creating the green feedback link.
Stating price is not mandatory but recommended. Complaining about price or complaining about pre-sale negotiations is inappropriate and against policy.
Buyer Beware! RunRyder cannot vouch for any seller's or buyer's credibility and will not accept responsibility for any transactions resulting from the use of this site.

Thursday, October 19 - 11:05 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online