Here is some photos of my Long Tail(10mm extend, with 7mm tail motor), Brushless ESC +HP05 Outrunner mCP X.
The tail motor mount is from MicroHeli,because RKH 7mm tail motor mount still need to wait about 2 weeks.
The Horizon fin is custome made, so don’t ask me why you can’t found it from your RKH tail boom Support upgrade
These is not the final ver, because I still have 1 othe 7mm for test, & main motor will go with CM05, HP05 is over power!
Drink my 300mAH battery really fast!!
You can see the full upgrade RKH mCPX is 1.6g lightter than stock setup.
AFW of stock setup & full upgrade.
Full Upgrade with Hawk Power 30C(7.9g), Total: 44.7g
Stock Setup with Hawk Power 30C(7.9g), Total: 46.3g
some tips about assembly the carbon frame.
1. the carbon rod for attach the canopy wil be a little tight, use 1000 or 1200 sand paper to sand it a very little will be much more to insert.
2. read the manual before you start to assembly, all parts a small, NEVER TRY OVER TIGHT OR HANDLE TOO HARD!!!
3. when you found some parts really hard to insert, don’t try hard!! just use a 1200 sand paper to polish a very very little & keep try until just fit!!
4. Finally, again, NEVER try too hard on small CNC Alum parts or you’ll damage it!!