RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 569 views
Scorpion Power Scorpion Power
HelicopterNext D Rave-ENV-700 › ENV softening dampers
04-11-2011 01:23 AM  6 years agoPost 1
Pulento

rrVeteran

CHILE

My Posts: All  Forum  Topic

My dampers don't seem to brake off.

I fly hard at about 2020RPMs and it still give me some shakes on hard ciclic stops.

Running Radix 710 and Funtech 3D paddles (damn good and damn expensive).

On the last part of an auto my ENV still woobles so I will sand the dampers a bit.

Do I need to sand on the outer diameter or inner diameter ? Some people say inner and some outer but I do not know the definitive answer.

Thanks !

PM  EMAIL  GALLERY  Attn:RR  Quote
04-11-2011 01:25 AM  6 years agoPost 2
Wingman77

rrProfessor

Pulaski Tennessee

My Posts: All  Forum  Topic

I believe most are doing it on the OD. just curious, is this on a FBL heli? if so your gain being too high will cause similar problems.

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-11-2011 04:14 AM  6 years agoPost 3
Pulento

rrVeteran

CHILE

My Posts: All  Forum  Topic

Flybared

Funtech paddles.

PM  EMAIL  GALLERY  Attn:RR  Quote
04-11-2011 09:20 PM  6 years agoPost 4
Sky Dancer

rrVeteran

Bryan, Texas

My Posts: All  Forum  Topic

Yep, sand the outside diameter.

Slide the dampers on the spindle and sand them down until they slip into the head block (not loose). Do not glue them in place....

You might also try a little weight on the flybar.

Don C

Keep up your rotor speed !

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 569 views
Scorpion Power Scorpion Power
HelicopterNext D Rave-ENV-700 › ENV softening dampers
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Friday, November 24 - 8:44 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online