RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 998 views
Scorpion Power Scorpion Power
HelicopterFlybarless Rotor Head SystemsBeastX › BeastX servo compatibility question.
02-18-2011 06:31 PM  6 years agoPost 1
JasonJ

rrKey Veteran

North Idaho

My Posts: All  Forum  Topic

Thinking of putting a BeastX on my Rappy 50 V2. My cyclic servos are Hitec 5625MG and my pitch servo is a Futaba 9452. I looked at the servo chart on the beast website and they don't show the 5625. Any reason why my setup wouldn't work with a Beastx?

PM  EMAIL  GALLERY  Attn:RR  Quote
02-18-2011 09:45 PM  6 years agoPost 2
Turkana

rrKey Veteran

Montreal,Quebec ,​Canada

My Posts: All  Forum  Topic

Should work without problem, you should just find out with how much you can pulse them otherwise they will fry.

PM  EMAIL  Attn:RR  Quote
02-19-2011 06:22 AM  6 years agoPost 3
Sidneyw

rrApprentice

Huntersville, NC

My Posts: All  Forum  Topic

I emailed Hitec for 5625mg frequency here is the answer -
I would try them at 120/165 and check the temp before I go 200hz for cyclic.
Thank you for choosing Hitec products. That servo uses a frequency of 333Hz with 1520uS.

Thank you,

Billy Tompkins

Customer Service Rep.

Hitec RCD, LLC

Multiplex USA

PM  EMAIL  GALLERY  Attn:RR  Quote
02-19-2011 01:43 PM  6 years agoPost 4
Turkana

rrKey Veteran

Montreal,Quebec ,​Canada

My Posts: All  Forum  Topic

If hightec says it's ok I would not worry to much, but it does not harm to start lower, so if you are not comfy with it start at 200 MHz .

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 998 views
Scorpion Power Scorpion Power
HelicopterFlybarless Rotor Head SystemsBeastX › BeastX servo compatibility question.
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Monday, November 20 - 7:21 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online