RunRyder RC
 0  Topic Subscribe
WATCH
 1 page 458 views POST REPLY
HelicopterFlybarless Rotor Head SystemsBeastX › Help with microbeast, gain light jumps during spool up
01-15-2011 07:42 PM  7 years agoPost 1
jesse

rrVeteran

Houston, TX.

My Posts: All  Forum  Topic

I've been helping a friend setup his microbeast. This isnt the first setup I've done. We can not figure out what's going on with this thing. It will intialize fine then we start to spool up the heli and it will violently start spinning around. All gyro directions are set correctly. When we spool it up I notice the gain light will turn on and change from different letters and the blue heading hold light will turn red and then back blue. We have swapped out receivers (2 futaba's and one spektrum trying anything at this point) it's done it with 2 differnt esc and bec combonitions, leads from beast to receiver, also two different beastx's did the same thing. We can make it happen by spinning the head fast by hand. it doesn't do it if we just spin the motor with no head or blades.I'm stumped I told him try a separte receiver pack today. Any other suggestions?

PM  EMAIL  GALLERY  Attn:RR  Quote
01-15-2011 08:04 PM  7 years agoPost 2
jesse

rrVeteran

Houston, TX.

My Posts: All  Forum  Topic

almost forgot heli is a protos 500 carbon with a compass fbl head

PM  EMAIL  GALLERY  Attn:RR  Quote
01-15-2011 11:14 PM  7 years agoPost 3
jyzoom

rrApprentice

Singapore

My Posts: All  Forum  Topic

what ESC and BEC combination have you try ?

PM  EMAIL  Attn:RR  Quote
01-16-2011 09:26 PM  7 years agoPost 4
jesse

rrVeteran

Houston, TX.

My Posts: All  Forum  Topic

Got it, Turned out that the wires run between the boom and carbon frame was giving a way static and was causing the problems. moved wires outside the frame and all is good.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 458 views POST REPLY
HelicopterFlybarless Rotor Head SystemsBeastX › Help with microbeast, gain light jumps during spool up
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Saturday, April 21 - 12:48 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online