RunRyder RC
 0  Topic Subscribe
WATCH
 1 page 484 views POST REPLY
HelicopterAlignT-REX 600N › link rod sizes ???
01-15-2011 04:47 AM  7 years agoPost 1
ronmad02

rrApprentice

Toledo, Oh - U.S.A.

My Posts: All  Forum  Topic

I have a 600n (silver glass frames) with a nsp head.. If I look up the (NSP) specs. It calls for 60 mm for the links between the bell cranks and the swash. If I look up the (N) it calls for 58.5m. So should I use the 60 or the 58.5mm Right now they are around 60 but my swash hits the guid pins on the wash out at full collective with cyclic input..

Thanks For the help

Ronmad02

ronmad02
T-rex 450se
T-rex 600n

PM  EMAIL  GALLERY  Attn:RR  Quote
01-15-2011 06:55 AM  7 years agoPost 2
nightstalker3D

rrNovice

DB-FLA

My Posts: All  Forum  Topic

Those numbers are just a starting point. If you're too high, lower all 3 links the same amount - just make sure you don't go too low.
Of course you'll have to go back through the mixing assembly to get all your links at the right geometry.

**It's not MANDATORY that there is NO binding at extremes - 99% of the time you'll never give those inputs in flight - that said, if you can eliminate it, then do it

PM  EMAIL  GALLERY  Attn:RR  Quote
01-15-2011 07:08 AM  7 years agoPost 3
ronmad02

rrApprentice

Toledo, Oh - U.S.A.

My Posts: All  Forum  Topic

sounds good.. Thanks . I went about 59 mm That gave me the clearance in both directions...

ronmad02
T-rex 450se
T-rex 600n

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 484 views POST REPLY
HelicopterAlignT-REX 600N › link rod sizes ???
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Friday, April 27 - 2:16 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online