RunRyder RC
 3  Topic Subscribe
WATCH
 2 pages [ <<    <     1     ( 2 )    >    >> ] 2267 views POST REPLY
Helicopter
e-
Mikado
Other › Trex 700E Mikado V-Bar 5.0/Futaba 8fg
01-11-2011 09:26 PM  7 years agoPost 21
uglyrider0078

rrApprentice

Natick, MA

My Posts: All  Forum  Topic

Trex 700E Mikado V-Bar 5.0/Futaba 8fg
Sorry guys if I confused you yes it's the R6108S-Bus receiver i'm using regular aligh servos Ds610 on the cyclics and Ds650 on the ruder
however i just got a pm explaining the v-bar actually controls all the servos so it will be one male wire from the S.bus port to the vbar and the unit will configure the servos, if i'm missing something please feel free to clarify

Team Miniature Aircraft

PM  EMAIL  GALLERY  Attn:RR  Quote
01-11-2011 09:37 PM  7 years agoPost 22
OICU812

rrMaster

Edson, Alberta, Canada

My Posts: All  Forum  Topic

Yes one wire male to male from sbus rx to the vbar aux port is all u need. Prior to all this bind ur rx to vbar, ensure u have put rx into hs mode first and bound to tx first as described in rx instructions in Futabas rx box. Set tx to one servo as well of course prior to bind. There after all ull need to do and use on tx is to set your throttle curves for flight modes and ur th hold of switch you desire.

...Once upon a time there were Nitros, flybars and frequency pins...

PM  EMAIL  GALLERY  Attn:RR  Quote
01-11-2011 11:31 PM  7 years agoPost 23
uglyrider0078

rrApprentice

Natick, MA

My Posts: All  Forum  Topic

S.bus receiver burn
you guys wont believe this and it's a good thing no one can see my stupid face i feel so terrible right now just got the S-Bus receiver from tower today i plug a 4.8V 3600 mah batt into it, plug it vertical instead of horizontal and the receiver almost burnt two link came off and i smell smoke i can't believed i'm so dumb now instead of programing the heli now i'll have to send it back to tower and they are probally going to charge me $80 bucks to fixed it. After the small amount of smoke i was still able to link it to the radio but as we all know too well i still need to get it check out what excuse do you guys think i can tell him so they won't charge me?

Team Miniature Aircraft

PM  EMAIL  GALLERY  Attn:RR  Quote
01-12-2011 12:01 AM  7 years agoPost 24
Ronald Thomas

rrMaster

Gainesville, Fl, USA

My Posts: All  Forum  Topic

Get ready to pay

Team MikadoUSA 480XXTreme, 550SX, 600SX, 700XXTreme, 800XXTreme!!

PM  EMAIL  GALLERY  Attn:RR  Quote
01-12-2011 12:12 AM  7 years agoPost 25
uglyrider0078

rrApprentice

Natick, MA

My Posts: All  Forum  Topic

s.bus receiver burn
do you think they'll waive the fee if i just tell them the pins came off

Team Miniature Aircraft

PM  EMAIL  GALLERY  Attn:RR  Quote
01-12-2011 12:17 AM  7 years agoPost 26
Ronald Thomas

rrMaster

Gainesville, Fl, USA

My Posts: All  Forum  Topic

The thing about electronics I they always tell what happened. They are going to ope that rx and see the burned traces and know exactly what happened. Since it is not a warranty issue they will most likely charge you. You should just tell the truth and hope for the best.........Ron

Team MikadoUSA 480XXTreme, 550SX, 600SX, 700XXTreme, 800XXTreme!!

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 2 pages [ <<    <     1     ( 2 )    >    >> ] 2267 views POST REPLY
Helicopter
e-
Mikado
Other › Trex 700E Mikado V-Bar 5.0/Futaba 8fg
 Print TOPIC  Make Suggestion 

 3  Topic Subscribe

Sunday, April 22 - 11:54 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online