RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 1981 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Blade
Blade 400 › 3D linkage lengths
06-02-2010 03:49 AM  7 years agoPost 1
iroc_254u

rrNovice

maine

My Posts: All  Forum  Topic

Awhile ago back I remember seeing a link that shageowedwhat the length of the linkagage rods should be. I just replaced. A ball linkage after one broke in flight and want to make sure I have it back to the same length. Anyone know where I can find it?

PM  EMAIL  GALLERY  Attn:RR
06-02-2010 05:17 AM  7 years agoPost 2
FxstsTwo

rrNovice

Capitan N.M. USA

My Posts: All  Forum  Topic

Evening iroc_254u. When I need any info on the Blade 400,I go to "The Blade Bible" You can pretty much find what ever you need about the Blade 400.http://www.slyster.com/heli/b400bible.html I hope this helps.-----Roger

PM  EMAIL  GALLERY  Attn:RR
06-02-2010 03:17 PM  7 years agoPost 3
FxstsTwo

rrNovice

Capitan N.M. USA

My Posts: All  Forum  Topic

Blade 400 (linkage lengths)

Morning iroc_254u, In case you didn't get what you need yet I went ahead and looked them up for you.
33.90mm(x2)Washout Base to Flybar Paddle Control Frame Rod Linkages
61.25mm(x2)Inner Swashplate to Bell Mixing Arm Linkages
45.00mm Pitch Servo Arm to Swashplate Linkage
51.65mm Elevator Bell Crank Arm to Swashplate Linkage
70.75mm (x2) Elevator Servo Arm to Elwevator Bell Crank Arm Linkages
56.85mm Aileron Servo Arm to Swashplate Linkage
After setting above the linkages the bottom of the plastic swashplate outer ring and bearing should measure approximately 16.25mm from the top of the main frame.

Hope this helps and gets you back into the air.----- Roger

PM  EMAIL  GALLERY  Attn:RR
06-02-2010 03:40 PM  7 years agoPost 4
iroc_254u

rrNovice

maine

My Posts: All  Forum  Topic

Thanks for looking them up for me. I looked in the bible and could not find them. Thanks once again

PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 1981 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Blade
Blade 400 › 3D linkage lengths
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Saturday, September 23 - 10:43 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online