RunRyder RC
 4  Topic Subscribe
WATCH
 1 page 458 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Align
T-REX 250 › is anyone using the gov mode on the 250 se?
01-02-2010 01:30 AM  7 years agoPost 1
FenderBean

rrElite Veteran

Clarksville, TN

My Posts: All  Forum  Topic

im runnung all stock electronics and i was just wondering about the gov mod, is it good to run? also is the 3.2 volt cutoff for the esc good? if so it seems like a good way to not draq your lipo to low. that should put your volts at 9.6 which is fine for for lipos.

PM  EMAIL  GALLERY  Attn:RR  Quote
01-02-2010 01:43 AM  7 years agoPost 2
Louisiana Helicam

rrKey Veteran

West Monroe, LA

My Posts: All  Forum  Topic

I tried governor mode but didn't like it as much as fixed.

www.louisianahelicam.com

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
01-02-2010 02:17 AM  7 years agoPost 3
FenderBean

rrElite Veteran

Clarksville, TN

My Posts: All  Forum  Topic

well what did u not like about it

PM  EMAIL  GALLERY  Attn:RR  Quote
01-02-2010 03:15 AM  7 years agoPost 4
rocco.sj

rrVeteran

California,

My Posts: All  Forum  Topic

You can try both settings gov and non gov mode on your T250 which is fine. I personally don't like the gov mode because it seems to draw more current on the lipo's for some reason. I know other fliers have success and like the gov mode on which is fine. Make sure if you run gov mode have a little bit room on you're throttle curve. Run like 85% flat curve first or if not happy with heedspeed go to 90% flat.

JR Americas
Evo Power Battery
Radio Frequency RC

PM  EMAIL  GALLERY  Attn:RR  Quote
01-02-2010 04:22 AM  7 years agoPost 5
FenderBean

rrElite Veteran

Clarksville, TN

My Posts: All  Forum  Topic

any thoughts on the cut off voltage feature?

PM  EMAIL  GALLERY  Attn:RR  Quote
01-02-2010 04:49 AM  7 years agoPost 6
rocco.sj

rrVeteran

California,

My Posts: All  Forum  Topic

I have mines at mid cut-off voltage now with no issues.. I used to have it on high which was fine at the beginning until you put certain cycles on your batteries and for some reason when doing hard 3D the power goes out. Changed it to mid cut-off and never looked backed since. The only difference i see now from high to mid is when flying the t250 your batteries will drain lower then 9.6v. When you do set it to mid have a timer set for about 4min on hard 3D and 5min on mild 3D or any sport flying.

JR Americas
Evo Power Battery
Radio Frequency RC

PM  EMAIL  GALLERY  Attn:RR  Quote
01-02-2010 03:43 PM  7 years agoPost 7
Darren Lee

rrElite Veteran

Woodstock, GA

My Posts: All  Forum  Topic

I see no reason whatsoever to use gov mode on the 250. Flat 100% throttle curve works great.

As far as voltage cutoff, you will be damaging your lipos if you fly until it kicks in. Use a timer and don't discharge more than 80% of the lipo's rated capacity.

PM  EMAIL  GALLERY  Attn:RR  Quote
01-02-2010 10:37 PM  7 years agoPost 8
Richardmid1

rrProfessor

Leeds, England

My Posts: All  Forum  Topic

What Beeflyer2 said!

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 458 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Align
T-REX 250 › is anyone using the gov mode on the 250 se?
 Print TOPIC  Make Suggestion 

 4  Topic Subscribe

Tuesday, October 24 - 6:55 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online