RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 579 views POST REPLY
Scorpion Power Scorpion Power
HelicopterSynergy R/CSynergy N9 › Kasama Blade Grip kit ? for N9
12-29-2009 08:55 PM  7 years agoPost 1
MMA0419

rrNovice

Allentown, PA USA

My Posts: All  Forum  Topic

Are there any pilots out there who are flying their N9 with the Kasama Blade Grip kit?? If so, could you post a pic as to how you have it set up? Has anyone noticed a need to modify and or dremel the recessed areas where the nut fits on the bottom of the grips??

PM  EMAIL  GALLERY  Attn:RR  Quote
12-29-2009 09:18 PM  7 years agoPost 2
greger

rrApprentice

Mesa, AZ

My Posts: All  Forum  Topic

you can look in my gallery at mine... no need to modify anything

PM  EMAIL  GALLERY  Attn:RR  Quote
12-29-2009 09:30 PM  7 years agoPost 3
MMA0419

rrNovice

Allentown, PA USA

My Posts: All  Forum  Topic

Wow, very nice looking! I'm not FBL yet, I have a completely stock head except for the grip kit. I downloaded the "instruction" page for the kit from kasama.com and it shows how the mixers mount to the grip arms, I want to know if I can use the stock pivot balls from the stock mixers? One of them is shorter than the other, how do they mount?

PM  EMAIL  GALLERY  Attn:RR  Quote
12-30-2009 12:30 AM  7 years agoPost 4
Jamien9

rrApprentice

Ashford, Kent, UK

My Posts: All  Forum  Topic

I had the grip kit on mine last year, fitted no problems without the need to modify anything. Now I have the full Kasama head assembly

PM  EMAIL  GALLERY  Attn:RR  Quote
12-30-2009 08:50 AM  7 years agoPost 5
whaleboy

rrApprentice

Los Angeles, CA

My Posts: All  Forum  Topic

I went FBL and went the homemade route with the Kasama grips. When I got them the arms did not fit into the channel in the grips. I had to file a fair bit of material off to get them to fit. Sounds like a different problem from what you are describing, but I wasn't too impressed with their quality control considering how much filing I had to do to get the arms to fit...

-David

PM  EMAIL  GALLERY  Attn:RR  Quote
12-31-2009 12:41 AM  7 years agoPost 6
MMA0419

rrNovice

Allentown, PA USA

My Posts: All  Forum  Topic

I found the grip arms to fit extremely tight as well although I did not have to file them... it was close. On one of my grips the recessed area on the bottom where the nut fits was not lined up with the hole, its off by about 1mm and I had to dremel a little out so it would fit.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 579 views POST REPLY
Scorpion Power Scorpion Power
HelicopterSynergy R/CSynergy N9 › Kasama Blade Grip kit ? for N9
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Thursday, October 19 - 1:50 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online