RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 449 views
HelicopterSynergy R/COther › Hyper Drive bearings
09-02-2009 03:34 AM  8 years agoPost 1
Chuck Bole

rrElite Veteran

Tulsa Ok. U.S.A.

My Posts: All  Forum  Topic

Anybody had any luck putting a regular Synergy TT support bearing on a Hyperdrive TT? I have some on order but i don't think they are gonna make it before the funfly this weekend. Everybody seems to be out of them. I'm pretty sure i can get a set of Synergy TT bearings here by Friday from Ron..
chuck

Team Synergy Field Representative / Thunder Power

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
09-02-2009 04:15 AM  8 years agoPost 2
cdrking

rrElite Veteran

Seattle

My Posts: All  Forum  Topic

I have never tried it but it should work. The one thing I found with a recent N9 build is that the stock setup fits VERY, VERY tight into the tail boom. Not sure why it was so tight, I did lube them very good too. This was a recent kit.

I have a Hyper tube that I can try fitting the stock bearings onto if you need me to check.

Jeff

To hover is divine, the alternative is rather PLANE.

PM  EMAIL  GALLERY  Attn:RR  Quote
09-02-2009 04:29 AM  8 years agoPost 3
baddynergy

rrElite Veteran

sierra madre, ca- usa

My Posts: All  Forum  Topic

Both tubes are the exact same size, so theoretically it should work. I dont have any stock bearings to check for actual fit though.

**Unattended children will be givin a shot of espresso and a puppy**

PM  EMAIL  GALLERY  Attn:RR  Quote
09-02-2009 04:42 AM  8 years agoPost 4
Chuck Bole

rrElite Veteran

Tulsa Ok. U.S.A.

My Posts: All  Forum  Topic

I'll get some from Ron just incase the Hypers don't make it in time..
thanks for the replies man...
chuck

Team Synergy Field Representative / Thunder Power

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
09-02-2009 06:01 AM  8 years agoPost 5
Bart B

rrKey Veteran

chicago illinois

My Posts: All  Forum  Topic

It fits fine.
The only problem you may have is a tight fit with the stock o-rings.

PM  EMAIL  GALLERY  Attn:RR  Quote
09-02-2009 06:06 AM  8 years agoPost 6
dreed129

rrApprentice

Albuquerque, NM

My Posts: All  Forum  Topic

Try using the tube that the Hyperdrive TT came in to push the bearings in. Put lots of Tri-flow down the tube. They are a very tight fit.

-- Dave

3D or Bust!!!

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 449 views
HelicopterSynergy R/COther › Hyper Drive bearings
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Tuesday, December 12 - 8:00 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online