My Posts: All Forum Topic
I'm normally a scale type guy, but I'm trying to put my Trex 450 back into service as a 3D machine. I've never done a 3D set up on anything and I'll tell you up front that I have no idea what I'm doing. I've been trying to set up my negative pitch curve but cant seem to figure out how to do it. I've figured out the throttle curve, but getting negative pitch on my blades is escaping me. I've read that section over and over in the manual but still haven't figured out how to get negative pitch on my blades. Is there anyone else out there operating a futaba 6EX who can shed some light on this for me? Is there already a thread out there somewhere that I can look at that will walk me through the set up beginning to end?
There is very little in this world that a Hellfire and a burst of 30mm can't fix