RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 598 views
Scorpion Power Scorpion Power
HelicopterAlignT-REX 700N › AR7100R Sensor routing on 700
12-26-2008 08:23 PM  8 years agoPost 1
latesleeper

rrApprentice

OH

My Posts: All  Forum  Topic

How did you guys route the wire for the crankshaft sensor on the 700? Just going through my setup and trying to clean it up a bit. If I route it between the frames, the wire is too short to reach the receiver. I guess I could use a servo extention but not sure if that's okay. If I route the sensor wire outside the frame, it's not very clean. The receiver is mounted on the top part of the electronics tray.

PM  EMAIL  GALLERY  Attn:RR  Quote
12-26-2008 09:43 PM  8 years agoPost 2
exceljay

rrNovice

Glendale, CA

My Posts: All  Forum  Topic

Yes You can use servo extention wire.
Also when you mount the sensor, Don't push all the way down, Use 50size point, that will work batter.

TREX 700N YS91sr+SB19,GY611,3x8717@8V,AR7100R,Switchglo,CY710SB

PM  EMAIL  GALLERY  Attn:RR  Quote
12-29-2008 07:52 PM  8 years agoPost 3
latesleeper

rrApprentice

OH

My Posts: All  Forum  Topic

Thanks for the pics. I went ahead and used a servo extention.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 598 views
Scorpion Power Scorpion Power
HelicopterAlignT-REX 700N › AR7100R Sensor routing on 700
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Sunday, November 19 - 8:54 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online