RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 444 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Blade
Blade 400 › 3D belt height in sight hole?
12-14-2008 08:15 PM  8 years agoPost 1
helibro

rrVeteran

hamilton, ohio

My Posts: All  Forum  Topic

were should the belt be when you look through the site hole? mine is more to the bottom, this is after no crashes or problems i was just woundering.

PM  EMAIL  Attn:RR  Quote
12-14-2008 09:12 PM  8 years agoPost 2
wtvariety

rrVeteran

Charleston wv

My Posts: All  Forum  Topic

about center with some tension it should not touch if pressure is applied!!

PM  EMAIL  GALLERY  Attn:RR  Quote
12-14-2008 10:43 PM  8 years agoPost 3
HeliFisher

rrVeteran

Verdi , Nevadafornia

My Posts: All  Forum  Topic

Mine sits a little low in the sight hole. Just below center. Seems to work fine.

The less a man makes a clarative statement, the less likely he is to look like a fool in retrospect.

PM  EMAIL  Attn:RR  Quote
12-15-2008 01:34 AM  8 years agoPost 4
StevenT

rrVeteran

Dallas, GA USA

My Posts: All  Forum  Topic

It should be in the middle, but sometimes mine has run low too. All that happened when I checked the belt was a little wear on the edges. Look at the tail belt guide wheel. If your belt in wearing, you should see some of it on the guide wheel.

Steven

Shhh, don't tell the wife.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 444 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Blade
Blade 400 › 3D belt height in sight hole?
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Wednesday, October 18 - 9:06 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online