RunRyder RC
 4  Topic Subscribe
WATCH
 1 page 1797 views POST REPLY
Scorpion Power Scorpion Power
HelicopterAlignT-REX 600N › New Swashplate for 600N
12-14-2008 05:14 PM  8 years agoPost 1
VANHELI

rrVeteran

Omaha,Nebraska

My Posts: All  Forum  Topic

Has anyone else tried this on there 600N? So far I think it is the best upgrade I have done. I wonder why the Nitro Super Pro doesnt come with it. The ESP does.

PM  EMAIL  GALLERY  Attn:RR  Quote
12-14-2008 05:44 PM  8 years agoPost 2
PAHelinut

rrVeteran

PA USA

My Posts: All  Forum  Topic

Do you have the part#?

PM  EMAIL  GALLERY  Attn:RR  Quote
12-14-2008 05:50 PM  8 years agoPost 3
VANHELI

rrVeteran

Omaha,Nebraska

My Posts: All  Forum  Topic

The swashplate is HN6101-84
The Elev. arm is HN6102-84

The -84 means blue. They also have it in grey/green and black

PM  EMAIL  GALLERY  Attn:RR  Quote
12-14-2008 05:55 PM  8 years agoPost 4
PAHelinut

rrVeteran

PA USA

My Posts: All  Forum  Topic

Thanks!

PM  EMAIL  GALLERY  Attn:RR  Quote
12-14-2008 07:41 PM  8 years agoPost 5
bah7566

rrVeteran

Colorado

My Posts: All  Forum  Topic

It's a good looking upgrade but I am not sure if there is any performance improvement over the older set up.

I am a Heli addict!!!

PM  EMAIL  GALLERY  Attn:RR  Quote
12-14-2008 08:12 PM  8 years agoPost 6
VANHELI

rrVeteran

Omaha,Nebraska

My Posts: All  Forum  Topic

less slop

PM  EMAIL  GALLERY  Attn:RR  Quote
12-14-2008 08:27 PM  8 years agoPost 7
JAGNZ

rrProfessor

Auckland, New Zealand

My Posts: All  Forum  Topic

Nice upgrade but it is $$$$.


Jason Greenwood

www.3dheli.co.nz

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
12-15-2008 12:21 AM  8 years agoPost 8
buzzsaw

rrElite Veteran

Southeast USA

My Posts: All  Forum  Topic

I have it on mine,Had to increase the cylics from 8to9 to regain the speed.Where I noticed the change was in negative inverted pushouts I did not have to fight it as much to keep it level.All in all,nice improvment form Align with the new elevator arm.

SkySpy Aerial Video

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
12-17-2008 01:59 PM  8 years agoPost 9
roglan

rrNovice

Norway

My Posts: All  Forum  Topic

The 600N Super Pro im building right now came with the new swach.

Edit: After examining its actually the old version. hmm.

PM  EMAIL  Attn:RR  Quote
12-17-2008 07:05 PM  8 years agoPost 10
DWS6

rrKey Veteran

Newark,DE

My Posts: All  Forum  Topic

If using the elevator arm you don't need a new swash correct? You only need the ball without the long pin that typically goes through the swash guide or is the swash offset different. Is a new swash necessary?

Dave Williams
Team Align

PM  EMAIL  GALLERY  Attn:RR  Quote
12-17-2008 07:20 PM  8 years agoPost 11
CrashMaster91

rrApprentice

Phoenix, AZ

My Posts: All  Forum  Topic

I actually just instaled the new setup. I still have the original upgraded swash. Not the blue or black, but the greenish one. I also have the matching elevator arm. But in the elevator arm kit, they give you everyhing to replace the old one. Yes, even the ball for the swashplate. I did notice less slop. Still havent had the chance to fly it yet. Been to busy with the vibe 50 and 90.
But I'll tell you when I get the chance.

PM  EMAIL  Attn:RR  Quote
12-17-2008 10:26 PM  8 years agoPost 12
roglan

rrNovice

Norway

My Posts: All  Forum  Topic

I just ordered the new elevator arm set in black.
Nice that you can use your "old" swash.

PM  EMAIL  Attn:RR  Quote
12-18-2008 01:02 PM  8 years agoPost 13
Alexander01

rrVeteran

Sweden

My Posts: All  Forum  Topic

The best upgrade for my 600N was $$$$$$-ish V-bar + Mikado conversion kit

QuickUK Team Pilot SAB Team Pilot

PM  EMAIL  GALLERY  Attn:RR  Quote
01-05-2009 06:23 PM  8 years agoPost 14
PAHelinut

rrVeteran

PA USA

My Posts: All  Forum  Topic

Ok just picked up the HN6101-84 "new swash" and I have a question. You can use the stock guide that comes with the 600N kit with the new swash if you don't have the upgrade elevator arm correct??

I ask because in the box with the swash came the linkage balls but not the long one that would go up and down in the guide.

PM  EMAIL  GALLERY  Attn:RR  Quote
01-05-2009 08:03 PM  8 years agoPost 15
VANHELI

rrVeteran

Omaha,Nebraska

My Posts: All  Forum  Topic

Yes,it will work fine.

PM  EMAIL  GALLERY  Attn:RR  Quote
01-06-2009 06:37 AM  8 years agoPost 16
digger123

rrApprentice

suffolk .uk

My Posts: All  Forum  Topic

new swash whats new about it this was on mine when i got it at the start of last summer may time its the super pros standard swash.i got the metal ele lever set from hongkong u replace the forward ball on the swash for a short one. it is easyer to set up the ccpm because the elevator arm is a fixed height flys the same.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 1797 views POST REPLY
Scorpion Power Scorpion Power
HelicopterAlignT-REX 600N › New Swashplate for 600N
 Print TOPIC  Make Suggestion 

 4  Topic Subscribe

Tuesday, October 17 - 3:06 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online