RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 419 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Mikado
Other › Logo 14 : screws to hold the motor to motor plate
07-09-2008 10:50 PM  9 years agoPost 1
JEY

rrNovice

Paris

My Posts: All  Forum  Topic

I had taken off my motor from motor plate and did not use my logo for a long time. I can't remember wich screw lenght is good to attach the motor Tango 45 06 with motor plate adaptor 2499. On page 11 of the manual it says to use 2 screws M3 x 12. It seems 12 mm is not long enough to screw into the motor adaptor plate. Perhaps I used M3 x 14 instead. Can you confirm ?

PM  EMAIL  GALLERY  Attn:RR
07-11-2008 09:51 PM  9 years agoPost 2
OICU812

rrMaster

Edson, Alberta, Canada

My Posts: All  Forum  Topic

depending onm which motor you will use will change the bolt you may have to use. Pretty simple, use what will work for the motor you wish to install, simply make sure you have 3-4 mm in the motor holding thread wise.

...Once upon a time there were Nitros, flybars and frequency pins...

PM  EMAIL  GALLERY  Attn:RR
07-11-2008 10:51 PM  9 years agoPost 3
kogibankole

rrKey Veteran

albuquerque/ibadan

My Posts: All  Forum  Topic

just make sure that the screws dont hit the fan right at the top of the motor. It should be easy to do. I used a flashlight to ensure that the screws went in, but didnt hit the fan.

if im not blade bogging youll find me pack puffing

PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 419 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Mikado
Other › Logo 14 : screws to hold the motor to motor plate
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Saturday, September 23 - 6:39 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online