RunRyder RC
 0  Topic Subscribe
WATCH
 1 page 378 views POST REPLY
Scorpion Power Scorpion Power
HelicopterRadio - Servo - Gyro - Gov - Batt › Switchglo on 9303 w/ Multigov and Solid-G
05-15-2008 04:16 PM  9 years agoPost 1
GScott

rrElite Veteran

Lewis Center, OH

My Posts: All  Forum  Topic

I was looking to add a Switchglo to my Synergy but currently only have a 7 channel Spektrum RX. My current config has the Multigov using the gear channel and the Solid-G on Aux2. I would like to keep the ability to run 3 different headspeeds on the Multigov so I don't think it's possible to add the Switchglo without going to a 9 channel RX. Anyone running this config with the Switchglo?

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR
05-15-2008 06:20 PM  9 years agoPost 2
Raptorchief

rrVeteran

Kalkaska, MI USA

My Posts: All  Forum  Topic

Switch Glo

Not sure if this will help, but, I have a 7C, with the 7 channel Rx and running a GV-1 and GY 401, what I did was run a Y harness off of the gyro gain channel, I have a switch on my radio that I can change between HH and Rate modes. When I turn the Rx on I wait for it to initalize in HH and then I can switch the Switch Glo off, when I am ready to start I flip the switch back in HH and the SG turns on for the 10 seconds, if needed I can toggle the switch and re-start the SG. This works good, I never fly around in rate mode only HH. Mark

I'm not a pilot, I'm a crash facilitator!

PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 378 views POST REPLY
Scorpion Power Scorpion Power
HelicopterRadio - Servo - Gyro - Gov - Batt › Switchglo on 9303 w/ Multigov and Solid-G
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Tuesday, September 26 - 3:05 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online